SX/SXi/SXi Pro My first build/first stand up

[Abbott]

I believe it was 90 bucks to have them done also break the edges on the intake and exhaust ports.

I also believe that i found the problem with the over heating. I am pretty sure it was due to one of the exhaust gaskets. I was waiting for about two weeks for them to then find out they where on back order!! :aargh4: So i just made my own but didn't realize that one of them needs to be solid to redirect the flow of the water cooling the motor. I ordered the right gaskets from somewhere else and they should be here today. So now hopefully with the right gaskets she will be ready to rip.

 

[Abbott]

Has anyone used one of these bilge pump mounts and if so do you have any pictures of how it goes?? I am a little confused on how it all mounts up

 

[97superjet]

^No idea on the bilge mounts.. I just epoxied the blue part of the pump right to the hull..are you running a sit down exhaust on this ski also?

 

[sxipro02]

looking at the picture the lower side of the mount will bolt on using the twp lower bolts of the driveshaft bearing support on the lower dash behind the e box. The bilge pump will then bolt onto the flat section with four holes, the area in the top left of the pic.
I also agree with 97superjet, I have always just epoxied mine directly to the hull, the brackets have a tendency to break the blue basket section of the pump housing.