Super Jet NewName RN (rocker, short, new tray,hood,handlepole)

[NewName]

ill make them adjustable

 

[Brett M]

Looks Awesome! keep up the Good work!

 

[Byeai]

my wamiltons hood wieghs 15

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

 

[NewName]

Dont Tell my girlfriend

 

[NewName]

Let the Fun begin

 

[txsuperjetfreak96]

Looks good what is gfk

 

[NewName]

german word for glass layer

 

[MCrider]

He says F-it i'll make my own hood! NICE!

 

[NewName]

I just try something.
Hood will complete closed, air only through handepole. As seal i will use rubber on both sides, and a flat surface. around 1 inch rubber on rubber should be enough.
Just need to take my bracket and this stuff to do the middle of the hood. The hood in the back will become the same form then the tray, but its not 100 % done, so i got some time.

 

[ajmps1]

I think the hood looks a little too flat. I like curves tho...much respect on the build tho, just pluggin away man.

 

[SkiDiggity]

Amazing!!! can't wait to see how this hook comes out. I really like how it follows the curve of the ski. Great job!!! Keep it up!

 

[Byeai]

lol ha cant wait to see this

Sent from my SAMSUNG-SGH-I727 using Tapatalk 2

 

[NewName]

Nearly done.
Need to close some holes with foam, and Look in the middle. Iam Not sure how wide i should Make it. Need my Handlepole to have a Look.

 

[swapmeet]

Hahaha! Yes!

I love that you're making your own hood. Thats awesome.

The pictures make it look like the contour on the right side doesn't match the left, but if I can see that i'm sure you do to, or its just a goofy photo.
I'm not 100% following how you're gonna seal the hood, but it sounds like you have a plan so i'll wait and see what you come up with.

Awesome stuff man.

 

[NewName]

Both sides are identically. Just ty Handy pics. Hoodseal i Try it with Rubber.
I got a plan, but cant Tell in english

 

[txsuperjetfreak96]

Nice was curious how u was gonna do lip on hood where it sits on seal

 

[NewName]

I will keep the hood with 4 pins in position. Each corner of a, in the hood is always fixed, and lateral slip impossible. The sealing surface will be about 1 inch wide and flat. On each side is rubber, which is in the assembled state together. Front view hood holder or a threaded rod to tighten, and in the back the original holder, and a Hood Strap. That should be enough

 

[NewName]

The mid Tunnel is to wide, i will make it smaller. Its now around 9 inch, i will make it to around 7 Inches.
ty pictures also

 

[NewName]

Need to Shape it, its just cut

 

[MCrider]

Looks good

Sent from my SPH-D710 using Tapatalk 2