pipe mounting with ada head???

superjetincairns

superjetincairns

Location
Cairns Australia
I'm rebuilding my superjet 701 and have a gorgeous new ada head to go on but cant seem to figure out how the lord mount for the pipe is going to fit as the ada head has no mounting holes and due to the girdle design it appears as though its going to hang out too far for my pipe mount to bolt onto the cylinder. I have a riva red pipe and what looks like the original Yamaha lord mount.
Is there a simple solution to rectify this? can I buy a new mount, butcher the original one so it only uses the cylinder mounts or should I manufacture my own entire new exhaust mount?
Hopefully someone has done this before. Im looking for the simplest but strong and reliable option here.
 
T

txsuperjetfreak96

Location
amarillo ,tx
ja5u3y6a.jpg
 
superjetincairns

superjetincairns

Location
Cairns Australia
So my understanding is that i bolt the Ada mount on and then my pipe mount should bolt onto the cylinder and Ada mount just like it did with the original head fitted. I take it from that pic that those 2 rubber mounts and hexagonal spacers they're sitting on are your pipe mounts and not part of the Ada bracket, correct?
 
superjetincairns

superjetincairns

Location
Cairns Australia
ok it looks bad or difficult anyway.
if I sit the head on the cylinders and try to hold the exhaust mount in position it hits against the overhanging part of the head before it even gets close to where its supposed to bolt up to the cylinders, there's about 10 mm clearance between the mount and the cylinders. Also theres no way the vertical holes for the bolts that go down into the head will ever line up without removing a heap of the webbing from the mount in what looks like critical strength areas.
HHHEEELLLPPPP!!!!
 
superjetincairns

superjetincairns

Location
Cairns Australia
found an old thread with pics of a stock mount all chopped up and modified to fit, I guess ill get the die grinder and cutting discs out and make a huge mess on my bench, again!
unless anyone has any better recommendations.
 
VXSXH20

VXSXH20

Sionis Industries
Location
Mid-Atlantic
12438-148728e00865edb8b132a46dd7b740aa.jpg 12411-f4abfc4485d4577e904245383c09b100.jpg imagesCAN2ZEH2.jpg

Riva has their own bracket for the red pipe. the base hexagon plate mimics that of a stock oem head and bolt holes. a stock bracket with the oem lift loop will work on the riva pipes. I have not seen a Riva pipe bolted to an ADA mount. dont go hacking up your new head, you'll have to modify the bracket that attaches to the pipe itself. not the new ada mount or head..
 
Justinlowe948

Justinlowe948

Location
Antioch ca.
VXSXH20 said:
View attachment 260360 View attachment 260358 View attachment 260359

Riva has their own bracket for the red pipe. the base hexagon plate mimics that of a stock oem head and bolt holes. a stock bracket with the oem lift loop will work on the riva pipes. I have not seen a Riva pipe bolted to an ADA mount. dont go hacking up your new head, you'll have to modify the bracket that attaches to the pipe itself. not the new ada mount or head..
Click to expand...

I have a riva head and a factory type 9 dry pipe I'm tryin to find a mount can seem to find this riva mount. Does any one know well the ada mount work for me
 
You must log in or register to reply here.
Top Bottom