Protec pipe. What Jets? Info?

[INDebtSJ]

i think i heard the chamber that is from a sitdown bends the same way but sits lower than the sj one. not sure if thats right but i think i remember hearing or reading that. also the bolt pattern and opening from certain headpipes dont match up to stock 701 manifold. i know that for a fact. (think it came from a 650 lx)

great little pipe though imo and like bruce said dont even need to run the two mounts. they stay put real well with just the hose clamps

This one was on a SN originally. I have another chamber to try then that is on the VXR. Hopefully it is shorter!

 

[surfjunkie]

This one was on a SN originally. I have another chamber to try then that is on the VXR. Hopefully it is shorter!

then i think u would be good. it is a tight fit which is why they stay together so well with just the clamps

 

[INDebtSJ]

Well I am at a loss. Any ideas?
The chamber is just to low and too close to the waterbox to fabricate something.

 

[tor*p*do]

Water box goes in the nose of the ski, in front of the fuel tank. Where is you fuel tank?

 

[BruceSki]

This is a blaster.

Bring the chamber to a tig welder and have him put an elbow on the end of it. That's the only easy fix if it's down too low in the hull already.

You might have to cut the straight section off first to make that work.

 

[tor*p*do]

This is a blaster.
Bring the chamber to a tig welder and have him put an elbow on the end of it. That's the only easy fix if it's down too low in the hull already.
You might have to cut the straight section off first to make that work.

Oops, sorry. Saw the reference to a SN earlier on, my mistake.
The Blaster version of this pipe had a 90 at the stinger.

 

[INDebtSJ]

What do ya'll think about going with this waterbox. Cut the feet off then turf it?
http://www.x-h2o.com/index.php?threads/tdr-b1-waterbox.180264/#post-1909568

Probably cheaper than a welder.

 

[BruceSki]

I bet a radiator shop has a tig welder and would only charge you about $40 to put an elbow on that chamber.

 

[INDebtSJ]

Is the chamber SS or Aluminum?

 

[BruceSki]

Pretty sure those are stainless.

 

[INDebtSJ]

Thats what I was thinking. It doesnt feel or look aluminum.

 

[INDebtSJ]

Well poop!
I have my b pipe from my lay down swap lying around so I figured ,hell I will just stick that on and get a blaster chamber.
Took everything off ,got the mani on and BOOM the head pipe doesnt fit into the hull. Hits the side.
At first I thought it was the foam crap and that it needed removal. Took the gas tank out and then the foam...still doesnt fit.

I always assumed that the only difference in pipes was the chambers. Now I have a limited chamber coming and cant use that!