SB Products Billet SuperJet engine case

[wsuwrhr]

 

[wsuwrhr]

 

[wsuwrhr]

And away we go...

 

[wsuwrhr]

 

[SuperJETT]

jaw drop...

 

[The Penguin]

fap fap fap

 

[QuickMick]

Damn!

 

[guiness92]

wow!!!!!

 

[dbrutherford]

Ask and you shall recieve.

Brian

Can I have one for free? Couldn't resist.



You guys have any plans for an 800 SXR billet cylinder?

 

[WB800BLASTER]

Very Nice

 

[waterfreak]

:eek2::eek2::eek2::bananalama:

 

[DangerBoy]

couple of bucks there as in couple hundred bucks each
glad I dont have to lift them , or clean out the chips those are going to make.

impressive work
cant wait to see the vid
Db

 

[wsuwrhr]

I couldn't keep up with demand if they were free. haha, but nice effort!!!

DASA is working on a Kawi cylinder. It has taken a little longer than we expected.

Brian

Can I have one for free? Couldn't resist.



You guys have any plans for an 800 SXR billet cylinder?

 

[wsuwrhr]

Thank you....

It's kinda funny, or sad really, 90% of the material ends up in the scrap bin.

The machine has a chip conveyer, they just dump into the handy dandy chip can.

Brian

couple of bucks there as in couple hundred bucks each
glad I dont have to lift them , or clean out the chips those are going to make.

impressive work
cant wait to see the vid
Db

 

[GDFL]

Thank you....

It's kinda funny, or sad really, 90% of the material ends up in the scrap bin.

The machine has a chip conveyer, they just damp into the handy dandy chip can.

Brian

I once had a machinist explain his job to me. He said that they take a chunk of metal, take off what the customer doesn't want and then give it to them. It seems about right, but that material removal sure can cost you.

 

[wsuwrhr]

That is a good one.

I always thought of myself as a hero. The part is captured inside of the material and I am rescuing it from inside. haha.

My job is boring sometimes. What can i say?

Brian

I once had a machinist explain his job to me. He said that they take a chunk of metal, take off what the customer doesn't want and then give it to them. It seems about right, but that material removal sure can cost you.

 

[DangerBoy]

I allway tell people my job is to make square things round , and round things square

Cg

 

[DangerBoy]

Thank you....

It's kinda funny, or sad really, 90% of the material ends up in the scrap bin.

The machine has a chip conveyer, they just dump into the handy dandy chip can.

Brian

ya We have a job that starts at 400 lbs and ends up at 18 lb after 5 hours

 

[chad]

incredible!

 

[wsuwrhr]

Almost done with the production run.


I'll try and post up some pictures today