bondra131
Thaat's braptaastic!
- Location
- Coeur d'Alene, Idaho
Wow not only are the needles stuck, there's a to. Of Sand and this clear waxy gel like poop all over in here! Corrosion too. How the f??? Does that get in the jet side...
But water shouldn't get past the rubber diaphragm? I had mass build up of junk consolidated around the needle and seat area. It was difficult to get the needles out and once they were out they were destroyed. One I had to drill on until it popped loose... Needles had so much build up and the rubber tips were lumpy all swollen and melted looking. Could something in my fuel be bad for these parts? Not sure what happened here but I'll be lucky if these carbs are even good... Cleaned the best I could and put new needles in the seats