Pressure in fluids at rest
Fluid pressure is most often the compressive stress at some point within a fluid. (The term fluid refers to both liquids and gases – for more information specifically about liquid pressure, see section below.)
Fluid pressure occurs in one of two situations:
1.An open condition, called "open channel flow", e.g. the ocean, a swimming pool, or the atmosphere.
2.A closed condition, called "closed conduit", e.g. a water line or gas line.
Pressure in open conditions usually can be approximated as the pressure in "static" or non-moving conditions (even in the ocean where there are waves and currents), because the motions create only negligible changes in the pressure. Such conditions conform with principles of fluid statics. The pressure at any given point of a non-moving (static) fluid is called the hydrostatic pressure.
Closed bodies of fluid are either "static", when the fluid is not moving, or "dynamic", when the fluid can move as in either a pipe or by compressing an air gap in a closed container. The pressure in closed conditions conforms with the principles of fluid dynamics.
The concepts of fluid pressure are predominantly attributed to the discoveries of Blaise Pascal and Daniel Bernoulli. Bernoulli's equation can be used in almost any situation to determine the pressure at any point in a fluid. The equation makes some assumptions about the fluid, such as the fluid being ideal[9] and incompressible.[9] An ideal fluid is a fluid in which there is no friction, it is inviscid [9] (zero viscosity).[9] The equation for all points of a system filled with a constant-density fluid is[10
Fluid statics or hydrostatics
Due to the fundamental nature of fluids, a fluid cannot remain at rest under the presence of a shear stress. However, fluids can exert pressure normal to any contacting surface. If a point in the fluid is thought of as an infinitesimally small cube, then it follows from the principles of equilibrium that the pressure on every side of this unit of fluid must be equal. If this were not the case, the fluid would move in the direction of the resulting force. Thus, the pressure on a fluid at rest is isotropic; i.e., it acts with equal magnitude in all directions. This characteristic allows fluids to transmit force through the length of pipes or tubes; i.e., a force applied to a fluid in a pipe is transmitted, via the fluid, to the other end of the pipe. This principle was first formulated, in a slightly extended form, by Blaise Pascal, and is now called Pascal's law.
