TNT B1 chamber

[holeshot]

I know its been covered but couldnt find it. How do we identify the different chambers, limited, superstock or stroker.

 

[tntsuperjet]

It's hard to explain, but by the shape of the cones.
There different lengths and shapes of the cones from the head pipe to where the pipe starts to taper back down.

 

[tntsuperjet]

Saw this on another form. Any benefit to running 3 sprayers on the pipe?

Actually just looked at this close. It was water jacketed for the first couple inches. Not threebspray bars.

 

[holeshot]

Must have been trying to keep from burning couplers so he could run it dry as possible

 

[Quinc]

I have sold the TNT V3 pipe design and all it's tooling, so that will help me get cought up.
I think this will be a good move for the end user as they plan to retail the pipe themselves and lower the retail cost.

Did someone end up making these? I haven't seen any new v3 since you where selling them.

 

[mbrick]

Did someone end up making these? I haven't seen any new v3 since you where selling them.

Is this what you are looking for?
https://www.blowsion.com/tnt-v3-exhaust-chamber

By the way, Tim, your work is VERY impressive. I enjoyed reading your comments through this thread.

 

[B.Mag]

For those who have added the fitting half way up the head pipe..I have normal water routing: water in at bottom of head pipe, out the top of head pipe to the stinger with a "T" and FCV. The leg of the "T" goes to a pisser. With the new fitting added to the head pipe and running to a pisser, do you eliminate the "T" that is before the FCV? Trying to figure out if I need to add another pisser or not.