Do you have an exhaust tube sticking out the back of your ski or is it flush with the hull?
Sent from my iPhone using Tapatalk
Water coming in somewhere.... RRP pipe??
- Thread starter Krenn Power Sports
- Start date
Sent from my iPhone using Tapatalk
Yes Instructions show it backwards. Water Box water line fitting goes to rear when in correct
- Location
- Fort Worth, Texas
ok.. i had the fitting in the back.. just changed it to the front....
- Location
- Fort Worth, Texas
sticks out about 1-2inches
- Location
- New Jersey 732
Not to derail the thread but can some one post the directions from RRP ? mine didnt come with instructions
- Location
- New Jersey 732
from the picture harbor posted the waterbox fitting should be facing the inside of the hull and towards the rear. How did you get it to be in the front ? Wouldn't that make it face the out side of the hull?
- Location
- Stouffville, Ontario
At least it wasn't something bad lol
- Location
- Fort Worth, Texas
the fitting isn't installed via RRP... they picture it as the fitting facing backward but on the front of the box... I turned it 180* so the fitting was on the back of the box... I just pulled it out and turned it around.. the box is now as the instruction from RRP show it.... hopefully it works...
Sometime pics are good.. It should orientated like this...
Attachments
- Location
- Fort Worth, Texas
the way this pic is, is how I had it but the fitting was in the back (left on your pic) instead of the front of the box...
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
I think there is some confusion going on here.
Back meaning rear of ski or stern
Front meaning front of ski or bow
I don't think they are talking about direction of flow @krenn
Sent from my iPhone using Tapatalk
Back meaning rear of ski or stern
Front meaning front of ski or bow
I don't think they are talking about direction of flow @krenn
Sent from my iPhone using Tapatalk
- Location
- Fort Worth, Texas
if this pic is correct and the font of the box is on the right side in the pic, that's how I now have it..... so confusing as that seems like it was keep more water in than let water out...
Install your box just like mine is, you can rotate the 3/8 fitting any way you want, but the bung its screwed into needs to be located where mine is... Away from the hull side wall and on the inside near the engine... Hopefully the pic makes sense... And you may have had correct, you'll know
- Location
- Fort Worth, Texas
This is how i have it installed now.... I had it turned around before... this is via the instructions
That's backwards, rotate the box horizontally 180..... So you had it correct the first time sounds like... I got 3.5 in h of Eva below mine. 2inch was not enough...