Search results

cam setup i have the 20/20 cam that i got for my sportbike and im pretty sure its waterproof but what do you keep the main camera in to keep it waterproof? Sorry to hijack been wodering about this for a while now.

cdi fixed it

He bought a new coil cause i thought that was the issue but apparently it is not. Then he went through all wiring and said it all appears to be good and grounds are in tack. All voltages and resistance are within range but still no spark even with the new coil. I am guessing this means the only...

to the top

any chance i could possibly borrow one from someone in the pensacola panama city area just to see if thats the problem. Im sure my bro would meet you or put a deposit down just so he doesnt have to waste the cash on something that might not be bad. If this is an option for someone that would be...

Thanks i appreciate the info ill let my bro know and see if he can find a 650 one as there are none for him to find right now. How different is the rev limiter? Is it a big difference? Or should that just be done as a test? Thanks again.

no ideas?

any suggestions?

Ok so i got the blaster running decently and giving good throttle response throughout the rpm range. Ski still had a slight miss but nothing too bad. Last time we took the ski out the ski started acting up again missing worse and worse. Decided to pull the s/s switch apart found the rubber boot...

well id start by pulling the carb off and cleaning it out real good and possibly rebuilding it if needed. Id also clear all the fuel lines out and make sure theres no junk in them and any fuel filters. Is the gas turned on? Did you try reserve yet? Maybe you have a pickup problem. Just a few...

Still got some problems. Ok guys i got the thing running decently and tuned the carb to where it had good response but i think the coil still needs to be replaced. My brother ordered a new coil so it should be to his house in a few days. However when he came down to pick it up and we were...

right on about the coil coming with the wires but i've read on here that the coil hardly ever goes bad just the wires, and that the wires can be replaced by cleaning out the old wire carefully and leaving the two post out of the coil to put the new wires on and then epoxy them in. I think im...

is that the same for the wb1 as well? Would you get a new one or just put new wires on the coil?

alright i got the thing running pretty good. Nice light brown/tan color on the plugs and responsive throttle. However it seems like out of nowhere it will start to miss at full throttle sometimes. Could this be the coil cutting out even though i couldnt pull any of the core out and resistance...

ok got the wires cut to where resistance would show on the meter finally. So now i can count that out of the equation. Now if i can only get this thing to be able to get full throttle.

what tools are we talking aout here? I used to be a an auto tech so i have a fair amount of tools. Wasnt sure though what was needed to add wires to the coil. Appreciate any and all info.

Maybe im wrong but i feel like i saw on here that maybe someone could replace just the two spark plug cables with better wire and then i wouldnt have to buy a coil. Is this an option or am i imagining things.

ok yup i was under the impression the low/ high were the needles. So the needle and seat is the needle that hangs suspended by the little clip under the cover.

to find the break do you suggest keep cutting a little section at a time and pull on the wire int eh center till it comes loose?

thanks for the quick replies guys. 1)Carb cleaning- When i cleaned the carb. I carefully and slowly pulled both sides of carb off. On the side with the filter and diaphrams there was a little bit of stuff in the filter. I cleaned that completely out with carb clean. As far as the diaphrams...