Search results

62T will have more power but laid out for mid to top end , the exhaust will have to be modified to work with your exhaust unless you are planning to go aftermarket, stock exhaust ( 5 ton pipe ) cant be used. Stator + CDI also different either one u use they should be matched ,as well as the...

ahh ...no show ...I know why , yeah yeah, always having fun ......but you know water hurts less right ? September 24 th ?? ...

Chinese baring in crank ...the real good poop

A set of cut back spark plugs .....

sbt starter ........and smuggy sealant on cases to cylinder leads me to think is this a SBT rebuilt engine ? oh oh oh

boots will have between 2-5 resistance, if its more might have to cut back coil ( boot side ) you do not have to remove stator to ohm it ,do that from electrical box, green wires are charging u need to ohm the igniter side if thats ok ( ohms ok within tolerance ) Ohm out your coil pack orange...

I would start with SS switch, disconnect black and white and see if it runs ... Then I would OHM out stator

Phil has worked on several skis with the older version and newer version of the 50'ds ... with temp changes and barometric pressure changes even during competition time ( lots of water gets stirred up and air has more moisture ) they are a tad sensitive to get dialed . We utilized the Dasa...

scary ..

wow ....always stuff randomly popping up

A) Leave tray in place, drill holes in rear , stand ski up let drain for a week or 2 , compressed air , 2 part foam fill the hole , shave , and epoxy glass in closed , now install footholds. B) Take the tray out , plenty of instructions of other everywhere here and on inter web , add cooling...

super deal ....if u need a tampon :0)

is this the first out of the 3 events in that region, always getting confused

planning .... any info on camp grounds, hotels ....etc anyone

Buy a good hull, one that u can grow on with different engine sizes and pumps....we went thru the complete and now " unnecessary " discovery process starting with self built to cheap aftermarket to better....and so on.....times have changed, >> proof-en products available A good light hull...

good time for add cooling lines and scupper if that is your thing

What do you look for in a hull? mostly bolts/screws i dropped ....sorry just had to get that in here... ;0)

Did u check to shaft that it was not already bent prior to putting the tighter impeller on ? It just takes little with a bent shaft if your clearance are not proper... the impeller snags and the rest is just additional damage

Brappy New Year to you too !!!!

I like the brave the wave ...that looks like a fun event ...Aug 2022 its happening ?