Search results

  1. C

    Fx1 parts

    I have a stock 122 mm prop, pump housing and wear ring. Wear ring and prop have damage. $40 + shipping for all. Will sell individually
  2. C

    144 mm pump

    I have a 144 mm pump with some damaged vanes, see pics. $20 +shipping
  3. C

    SOLD Blowsion 144 mm pump shoe

    Bump
  4. C

    SOLD Blowsion 144 mm pump shoe

    Bump
  5. C

    SOLD Blowsion 144 mm pump shoe

    This one is a little larger than stock to fill the gap when the stocker is removed. Brand new $50 plus shipping
  6. C

    Front foothold

    Sold
  7. C

    Front foothold

    Front foothold for superjet or other $35+ shipping
  8. C

    Installing tubbies with no pre drilled holes

    I haven't bought most materials yet so this is very helpful, looks like I have to do a little research on the gel coat
  9. C

    Installing tubbies with no pre drilled holes

    I plan to then fill the gaps in with thickened epoxy. I'm also filling in some big gouges on the bottom so the whole thing will get a gel coat
  10. C

    Installing tubbies with no pre drilled holes

    I have a set of tubbies with no holes in it, but every install thread has one with holes. So I just buy fiberglass screws, do some pilot holes to line it up, thickened epoxy on the back. This all sound good?
  11. C

    Want to buy fx1 intake scoop

    Looking for an intake scoop for the fx1
  12. C

    What prop should I get

    Didn't even consider the hub size. So a swirl is the same size hub as stock?
  13. C

    What prop should I get

    An fx1 with a 144 mm pump, choppy lake waves, sometimes big waves, sometimes flat. I Like low end power, it's rare to be able to hold it wide open where I ride.
  14. C

    What prop should I get

    I have a ported 718 single carb, b pipe, stock 144 mm pump. Possibly an mad enhancer in the future. Kind of lost on what impeller to get. Any advise helps
  15. C

    Taking bearings off of the driveshaft

    I was able to get it out, but that would be an easier method for anyone else doing this
  16. C

    Taking bearings off of the driveshaft

    Is there a way to remove the bearings from the driveshaft without a press?
  17. C

    How to disassemble pump

    Can anyone give me a hand. How do I get the driveshaft out? Tried pounding it both ways
  18. C

    144 mm Yamaha tilt nozzle

    Sold
  19. C

    Pump shoe and intake grate for a 144 mm swap

    Will a 144 mm pump shoe fit in an fx1? Will I have to grind the hull? If so will a superjet intake grate fit? I've noticed the superjet grate is held by two bolts at the back, while the fx1 has 1
  20. C

    144 mm Yamaha tilt nozzle

    Bump
Top Bottom