Search results

Aluminum tape and Vaseline. I did not mold it with foam in place but I do have a piece of 1/4in foam under the tank currently Sent from my SM-G996U using Tapatalk

I sure did. Made 4 total, all going strong Sent from my SM-G996U using Tapatalk

Alternatively, when I used to have a large aluminum tank in a different hull, I had issues with it staying put. I made a ratchet strap for it. Four mounting point, two forward, two aft. Thick padding on the bottom, that tank never moved again. The issue I ran into with rubber straps was that in...

Make a cradle, it will keep it 100% in place Sent from my SM-G996U using Tapatalk

Zeel brain Sent from my SM-G996U using Tapatalk

Contact New England Graphic. He's got the templates and can do the design Sent from my SM-G996U using Tapatalk

Very clean silver 760 short block. Crank is smooth and quiet. No corrosion on the cases. 250 760 ignition. Good clean fresh water piece. Includes flywheel. Missing start/stop harness. 250 Dual 44 carbs. Very clean in and out. All screws turn freely. 200 Bed plates, very clean no corrosion. 60...

I bought a hydraulic table from harbor freight. Cut it up a bit, mounted bunks on it and use it to raise/lower skis to almost any height needed. My aftermarket ski I built a stand that's the height of my tailgate, so I just slide it in my bed. My superjet i built a snap that's the height of my...

Do that top edge all the way down the the tray first. I wouldn't turf inside where the foothold bracket mounts. Itll be a bitch to adjust Sent from my SM-G996U using Tapatalk

Don't attempt to cut it once it's on. You'll never get a nice line. Instead, glue it to where you want the line and trim on the tray side. Glue the whole piece and the ski at the same time. Doing it in sections, the fresh glue will soften the already stuck glue. Get 3 coats on both the turf and...

2 sheets. You'll have about a half sheet of left over Sent from my SM-G996U using Tapatalk

Pm sent Sent from my SM-G996U using Tapatalk

Waxhead Sent from my SM-G996U using Tapatalk

Have one, PM me Sent from my SM-G996U using Tapatalk

I'm sorry lol Sent from my SM-G996U using Tapatalk

Just like the title says, looking for a clean thrust throttle lever in clear/silver anodize Sent from my SM-G996U using Tapatalk

Fit and finish plus available features the Scarab wins hands down Sent from my SM-G996U using Tapatalk

I have a 16 Scarab 195 HOI that I've but my skis on the swim deck from time to time. It's not as easy as you'd think and definitely not something you're doing also. Also, if you're shopping jet boats Scarab > Yamaha Sent from my SM-G996U using Tapatalk

I have everything you need. PM me Sent from my SM-G996U using Tapatalk

Theyre the same Sent from my SM-G996U using Tapatalk