Search results

Would you rather fly a Super Jet, or play around on a kawi?

Found a weak spot in my silicon on pump shoe. I was in a hurry trying to get on the water, took pump apart, put on freestyle pump cone and will reasemble carefully. I still want to be able to take it apart again to change the prop so I guess I will use silicon for now. Hopefully will be all...

I put new bearings and seals in the midshaft and siliconed the holder well. Could it possibly be my crank seals? The motor seam so rev good has decent response just wont hook up.

I just put back together my motor, and it ran good for the first hour and no cavitation, The next time out it started cavitating on me. It does it almost all of the time at both high and low rpms, I did get it to go again for a little bit, I tried to silicon the pump better, no luck. My...

roxx bar risers

looks good man! You going to put tubbies on it?

Thanks Garret, I have already been watching your build! You are doing awesome and I may do something to the front like yours. Keep up the good work. I will be watching. I have hung out with you at pismo before. We had the oak bbq pit out 2 free rides ago. I think you were having some...

I want to know if I should cut 3" or so off the back? What is the best way? Any good threads to look at? What is going to be best to fill the tray back up with? Ping pong balls and foam? What type of foam is going best and not cost too much. Should I convert it into a flat deck or just put...

I am just finishing up an X2 build. I will make a build thread soon. My ski came with a Pipe Head Water box, pump cone and 44 carb, I put a fresh stock motor back in. I shaved 60 lbs off the ski in misc parts and fiberglass, moved the battery under the seat cut three inches off the back, added...

I plan to mainly ride in the surf, any suggestions for a ride plate on an x2 which I has also been cut 3" off the back? I read through Vumad's ride plate post and it seemed alot of those guys were cutting them flush with the back. They also said to play around and see what you like.

Do a compression test, and try to look at the impeller for dings or chips.

So you cut your ride plate flush with the back and added a D cut?

I guess in the early model x2 it had an additional component seperate from the coil, but in the later years it was combined into one unit.

Nice work Bro!

I have a couple stock coils. One has 4 wires including a blue wire, but my coil on the ski only has 3, no blue one. I am trying to put in a a dales bad attitude coil that also has a blue wire. Does anyone know how to wire this coil for my ski? Thanks

comp testers are like $10 at auto zone, it is worth it to have one before you ever go check out a ski!

Comp Test My comp test was inaccurate due to no carb and pipe being installed plus, cylinders had fresh oil. Is it ok to run gaskets with domes intended for o rings. Why do you want 30 cc domes? What are pros and cons? I have also broken a few of those woodruff keys, can you get a higher...

what was causing it to backfire?

21cc domes, test is for sure accurate, like you say it would prob blow head off or destroy bottom end, I think I will put the damaged domes back in see what the psi is, any way how bad ass is Austin's ski?