Search results

My jet pump seal for my 122 pump is blown. I'm talking about the very large o-ring type seal that goes around the housing. I cannot find a replacement anywhere online. Called parker yamaha, no luck. Anybody know where to get one?

What should I set my pop off pressure to for a single mikuni sbn 44 for a bone stock fx1, for bottom end performance? I am running only 1 screen on a stock air box. elevation 5,000 ft.

Also, looking for bottom end performance

I have an fx1, all stock. I am going to upgrade the following: Skat-trak swirl impeller (17/22) Mo-flow intake grate Factory B Pipe mod chamber dented to fit in fx1 ADA head w/33cc domes Maybe an ignition enhancer later down the road. I live in Fort Collins, CO elevation 5,000 ft. What would...

So is it any good, or should I disconnect it? (I have an aftermarket one). If I disconnect it and do not plug the hole, will it cause water to get in my foam?

On my fx1, I just discovered this plastic little box with a bunch of holes in it, almost looks like a plastic cheesegrater. It is connected to a black hose that seems to go inside of the tray. Cannot take a picture of it now. What is this, and what is its purpose?

Ya for sure that'd be awesome, when is typically your first ride of the season? And RMBC, what does "girdled" mean? I plan on putting a factory b pipe, a prop, maybe a flywheel but thats pretty much it.

To increase compression, would you recommend a head? If so which one? And wet dreams, I ride at horse tooth

I ran fuel stabilizer, ran the engine dry of water, and fogged the carb and cylinders :)

think I'm gonna put fuel stabilizer in the full tank tomorrow , and then run her on the hose for a couple minutes. then clear the water, put fogging oil in carb and cylinders tun possibly remove water box. sound better?

This might sound silly, but would it help if i put blankets around the motor and under the hood?

I live in Colorado. This time of year it's very cold. I have my ski in my garage. The garage is not heated, but it rarely gets below 32 degrees in there ever. It is usually around 39-45 in there in these chilly months. Do I need to do anything in particular to keep a healthy ski in these...

I have never done hydroturf before and it scares me to do it on my fx1 with footholds. Ive read through all the threads, and I still want to have someone else do it. Wheres my best bet? Jet skis are not popular where I live, should I try motorsports stores, upholstery stores, etc?

I am looking to buy a pair of 615 footholds for my jet ski, anyone know where to buy them?

Has anybody ever used these footholds in an fx1 before? Judging by the size of the hold, it seems like it would be impossible to make them fit.

Bondo resin. I think I'm gonna go with the west system stuff though

When tuning a carb (for an fx1, sbn 44 i think), which way do you turn the screws to make it leaner? I have a 550sx and I turn the screws to the right to lean them, will this be the same for the sbn?

anyone?

I don't know whether to get the 635 thin or the 150 thick. According to the site, " The 150 Resin System is NOT recommended for the layup/laminating of fiberglass, carbon fiber or Kevlar. It is too thick and will not properly saturate the cloth. **

which type of resin from US composites should I get?