Search results

Interested in the works 201 pm sent

What about your stator? Is it aligned right?

So ive had multiple rockered blasters and i would run the splash guard, you can cut it off for sure but the spray off the front is crazy. I had the gen 1 rocker on mine and the spray was so bad i could barely see. So i glassed 1 into mine.

Im looking for prop info, I recently instaled a xmetal ss865 in my rockered blaster, running msd enhancer, 44 dual carbs, 144 pump with bored 85mm nozzle with xmetal trim, factory mod b pipe, xmetal water box, problem is I cant seem to get it to hook up off the line, just bouces off the rev...

Imbox is full, interested in enhancer if still for sale

Do you know the pitch of the props? I would be interested in buying 2 or 3 of them,

When I chopped the front off mine I used screws to hold it in place then did acouple layers on the inside. Then removed the screws and cut off the over lap on the outside. Except the bottom I left the over lap and just glassed in a bunch till it was smooth. Same for the rear, glass the inside...

Have you checked your needle an seat to make sure thier not leaking? Airbox off at an idle an see if gas is coming out of the bomb sight in the carb,

Almost sounds like your stator is breaking down. Either that or the cdi is, i would be seeing how strong your spark plugs spark cold compared to when thier hot,

Have you checked the 1 way valve on your gas tank? Is thier pressure in the tank after riding for 10mins? Do you have your temp sensor plug in? Might wanna disconect it and try again

So i had mine set up different when i ran a riva red, the top of the head should go to top of pipe, not to the bottom of pipe( by rear coupler)

Its already at the shop getting a new stem milled out for it. I couldnt beleive it snapped, happened the day after i read this post lol

Normal surf riding, not even a full season on the steering and snapped her right in half,

Have you installed a new pump shoe? Check to make sure the pump shoe isnt hanging below the bottom of hull. It needs to be smooth with hull.

Hey I will take the carbs and reeds, I can send the money thru paypal, I need to get them shipped to Ontario canada postal code K0M1S0, let me know what you think

I'm interested in the yamaha dual sbn carbs, are they good to go? I'm in Ontario Canada I'll pay shipping let me know the total for shipping is, do you have any pics?

Hey I recently bought a rocker kit from you, I was wondering if I could get another copy of the directions? I have the template just misplaced the instructions, Thanks

Hey steve Im looking for acouple sheets of hydro turf, looking for black turf any design is ok. Any help would be appreciated Thanks

my 62t 701 finger work, o ya so smooth, now just to port the cylinders and top crank case,

So ive been building up a 760, i'm doing the cylinder porting and wondering about doing the crankcase fingers, so im thinking about doing it a little different than the above pics, heres my thoughts, 760 engines are top end power and weak on the low end speed, so if filling the fingers will...