Search results

I love being able to open the hatch without needing to take the ski off. Worth the trade off to me.

Probably the best ski investment I've made... Sent from my EVO using Tapatalk 2

I'd like it!

Awesome vid and soundtrack! Wheres the HD res though?!

We had someone split his pelvis open riding one our skis. He tried throwing the bars at WOT on a gp1200 and literally went kart wheeling across the water. Carted off in an ambulance. Best part was he couldn't swim (didn't know that at the time). He had rabid lawyers calling him for weeks...

Can't go wrong with any of those. The couch mounts are pretty beefy compared to stock SJ mounts. I think I bought mine from skibonez here on the X. He had a bunch. I wanna say I paid 35 or 40 bucks shipped. He threw in a bunch of shims as well... although I didn't need any. Couplers lined right...

Replace all four with used yamaha couch mounts. Much stronger. Usually around 40 bucks (ish).

Top of the plugs are clean. The whole setup from JSS replaces stock boots with MSD boots. I was also running dielectric grease in the boots.

I've also got another stock coil...If the CDI swap fails, I'll give it a shot as well

I actually have a spare one. Bought it when I was troubleshooting a different problem that ended up being the stator. That's probably next on my list...

Just thought I'd follow up on this app. I tried it finally for the first time this weekend and it is awesome. Literally cuts out HOURS of sifting. I'll trade the little watermark on the lower right of the video for that kind of time saving any day. Check it out!

All right guys, this problem has been haunting me for the better part of a year now (since I BOUGHT the ski a year ago). I cannot figure out what is going on and have started to run out of ideas. Here are the symptoms: The ski will run great for 15-20 minutes into every surf ride. Suddenly...

I usually end up grinding a slot into them for a flathead screwdriver.

I love the 550. Bought my first reed motor 550sx a few years ago with a pretty decent amount of mods for dirt cheap (FP pipe, milled head, impeller, a/m carb, bars/quick turn plate, grips, finger throttle, intake/ride plate, a/m waterbox, nose brace). PO had rebuilt the motor (completely new...

That is unreal! I'd love to run that!

Thanks!

I posted up a while ago about my SN surf jet louie hood ingesting a significant amount of water. I think I've taken care of most of the issues (uneven hood lines, too many / too short breather tubes, bad hood seal etc...), but would like to install some hood hooks. I'm currently running a...

One other thing I found to be important...When doing the rails, don't lay the turf down on the top until the end. Do the sides of the rails and under the hold first. Then you can massage the turf around the top of the hold using heat and eventually around that corner where it begins to slope...

Yeah the dowel rods helped a ton - definitely a life saver. I picked that tip off of another thread somewhere on here. They stop any premature sticking. When your working with large pieces of turf, it's sometimes tough to keep track of the latter half while your trying to stick the other end...

I think I had to make a small relief cut in the black turf once I had test fitted it on the floor of the hold. Wasn't much...maybe an inch wedge cut out? I made a cardboard template for the area/shape I needed to cover with the black turf. Just cut it a little wide so I had some room for...