Search results

strange, my manual says .5mm for (a). the manual shows specs but it doesn't show how. i'm having the same problem with my superjet. i can't get my coupler to align. height isfine but gap (b) is uneven, just slightly. that (a) gap wouldn't 1mm out of alignment cause major vibration?and wear?

did you reinforce?

thanx. this is what i used to do my alignment. the only thing is that he says to go 2.5mm no less than 2 no more than 3. manual says 2-4mm and he torques bolts to 27 lb but manual says 12lb. big difference

inside starter button might be corroded . check the contacts inside.use steal wool or like an emery board(girlfriend will have one)on the contacts. it could even be the ground on the starter being loose. my truck actually had a similar problem (intermittent starting) and the ground was loose...

i am having the same problem. just reinforced hull and engine vibrates at idle. the back motor mount exhaust side is so blurry (like a paint can on a shaker)at idle but stops when revved. so you think i'm hitting the bed plate? i dented chamber on hull side so it wouldn't touch but not on...

so i got it aligned with straight edge but when engine is idling the back engine mount on exhaust side looks like a paint can in a shaker. vibrating a lot but when i rev engine it stops vibrating. when rpms come down it starts again. my coupler is straight but it seems to be about 3.1mm...

I have looked at other posts but haven't been able to get my answer. I pulled my motor and marked all the shims. When reinstalling i realized that the shims were not even. Is that normal? One corner has one .5mm shim the opposite has 2@ .5mmshims (closest to bulkhead). The shims toward the front...

Do i route steering cable around water box or between water box and gas tank?? the manual SUCKS!doesn't show anything. Any pics would be great. I have been searching the forum all day trying to find ONE SINGLE pic of the steering cable route in the front. does it go behind the exit tube of...

i am reinforcing nose area of my 95 sn. my question is for the bracket area do i use one piece of cloth or do i glass the bracket area then the sides and overlap? if i have the ski upside down the bracket area will be easy but running it up the sides to the bottom i will be fighting gravity. i...

Help. this is my first time working with glass. i am reinforcing inside the engine compartment. when i am sanding the top half above bond line, how far do i go? how can i tell?what do i look for?(surface texture).i know the layer of slopped on white paint goes. the next layer is tricky...