Search results

Lol.....I was testing the one with a pipe and head etc in a 13 hull to decide if I wanted to do mods to that motor also, just ended up showing me that it wasn’t carb related

Normally I would agree, but I swapped complete motors in the ski this summer and it did the same thing to stock motor I put in the hull

I do that when I remember to lol, I’d just like to figure out what is causing it

I haven’t made any changes. I did check fuel filter also

I’ve checked it, which it lets air in to keep tank from collapsing, and allows no air out, which I think is how it’s supposed to work?

I have a 07 SJ that seems to build a ton of tank pressure. It happens if it sits in the sun, sits in warm weather, every time you trailer or ride it. It’s enough to hear the pressure release (2-3x louder than my other SJs) when you take fuel cap off to add fuel. I’ve had it flood out (in 10mins...

What spring and n/s are you running?

I'm going to be running a ported 61x case and ported 61x cylinder bored to 84mm with a bpipe. 44mm stock carb Just wondering if any body has jetting/tuning ideas for this motor. Thanks

I have a h20 designs in my fx1. I had to cut 1.5-2 inches off inlet side and really try hard to make that fit. I didn't want to re weld it, so I just went with the super tight fit. Cutting the inlet helps when you need to clearance the chamber (bpipe) by the bond line, otherwise chamber hits...

Pretty much just makes it louder

Pm sent

Every part is correct. It's brand new from factory pipe a week ago....

Alright. I'll give that a try later on tonight

Just a regular hammer and cover with a towel when hitting or a rubber mallet?

I can't even fit a piece of paper in there, let alone a piece of turf

Pipe has been in and out of ski a couple times, just can't get it to fit without hitting somewhere

I got a factory mod pipe I'm putting in my fx1. The ski is reinforced and it's hitting along the bond area where it's been filled in. What should I do? Grind the weld down on the pipe a little, or try to dent pipe up? Or grind out the glass work? It's hitting where green markings are on the pipe.

Yup. Starter is junk

Thanks guys

I need some help.....I checked the threads on tech, but none of them applied. I have my motor and e box out of the ski. I have power from the battery to solenoid. Nothing happens when you hit start stop (yes the start stop is good) so I try to bridge the solenoid to turn starter and nothing...