Search results

Hows it going guys. Looking for some help figuring out the jetting for my hydrospace s4. Motor setup: Kawaski zxi 1100cc Stock bore Ada head @ 150psi Temp senser jump for timing advance Stock exhaust with dry pipe mod V-force 3 reeds 900 intake manifold ported Rhaas conversion plate Gp1200 carb...

It will be going into a hydrospace s4. Do you know what the stock jetting and pop off is?

Hey guys, I'm looking for recommendations on a good starting point with jetting. The motor is a 98 kawasaki zxi 1100. I am going to swap a set of keihin CDKll 38mm carbs from a earlier year to get rid of the horrible CV carbs. I will be adding a high compression head and aftermarket flame...

Ohh okay. Thanks for the info, I think I am going to hold off for know. I'm not sure if I will be using this e-box when I do my swap. Do you know what happens if you dont ground the plug wires when cranking with them out? When I bought it the guy did a compression test and did not ground them.

I just picked up a 98 kawasaki zxi 1100 for a Hydrospace 1100 build that I will be doing. I am going to run the ski for a while until I have all the parts together for the build. I noticed on the electrical box that most of the bolts where loose so I tightened them all down. Then noticed that...

Thanks for the advise guys! It's all set now. Drilled and taped to the next size up and used a hell coil. Hopefully I'll get the motor back in and be on the water this weekend.

Hey guys, I'm finishing up a full rebuild on my 2016 EME aerial 8. I'm still waiting on my cylinders from the machine shop so I started getting everything else ready to I can just drop my motor in when it is back together. When installing my motor mounts I found out that I have a striped motor...

Ok, thanks anyways. A friend is looking for a ski but we are in Massachusetts.

Where is it located?

How much does the mount on the right cost? I currently have the mount on the left and am not a fan of how the bars are not over the pivot point

I would like to purchase one of these templates. Can you you please send me a PM. I am new to the site so I can't message yet. Thanks

Thank you! I was starting to get a little concerned, this is my first time doing a pump and midshaft rebuild. Any tips or things to watch out for?

I have a few questions if you guys don't mind. I am trying to figure out how to change the bearings and seals on my pump. I have a Yamaha 61x motor and 144 pump in a 2016 eme aerial 8 hull. I just ordered the tool to remove the solas impeller and the holder for the drive shaft. I noticed last...

Hey Jetmaniac, I would like to buy some parts from you but I am new to this site and am not sure how to contact you. Could you please send me a pm or feel free to give me a call at 508-207-6998. Thanks