Blaster 200 HP Carbon Fibre Blaster with 155mm Pump

Pablo

Pablo

sqeez bth levrs & lean bk
Site Supporter
Location
georgia
I've got "blue balls" waiting on this thing to run! Post a vid before I make a mess all over myself.
 
C

Carbon Blaster

Location
Australia
104.jpg106.jpg107.jpg108.jpg109.jpg
111.jpg112.jpg113.jpg114.jpg
This is the battery mount we made for the carbon fibre Braille battery.
A carbon fibre plate will bolt to the rear of the bulkhead to support the back of the battery & an alluminium angle bracket to support the base of the battery.
Longer midshaft bearing housing bolts extend through the bulkhead to mount the alloy bracket.
Rubber was bonded to both brackets to protect the battery.
Rubber straps stretch over the top & around the side to hold the battery securely in place.
Very short positive & negative leads can be used from the starter motor & e-box to the battery.
The battery sits just above the prop shaft & weighs next to nothing, so not sitting directly on the base of the hull was not an issue.
 
Last edited:
beamer#184

beamer#184

Location
Spokane Valley WA
I have a Moded waveblaster 1 hull with a 1200 installed... with a GP1200 pump... What size pump do you suggest for Buoy racing... I currently have a old school 8 vein magnum in it... want to hook up better and uttilize the Protech built 1200... any suggestions would be appreciated...

Thanks James
 
You must log in or register to reply here.
Top Bottom