Laid a layer of carbon on the inside of the gunwales and the engine compartment.
The carbon i went with is a 11oz Twill Weave.
This was my first time laying carbon. It wasnt too bad, the hardest part was keeping the fibers together at the end of each cut piece. Other than that it went down good. just took my time to wet it out good, its harder to tell when its wet out enough because you cant see it like fiberglass.
I wet it out good and squeegeed out any excess resin.
For the engine compartment I was planning on doing two layers of 11oz for each side and 1 layer of 11oz for the bottom.
I might do an extra layer on the bottom
up at the nose.
Any reccomendations?
I still need to do the hand pole area.
Started the week by getting the whole engine compartment sanded with 40 grit on a die grinder to give my materials a good surface to bond to. Did the same for the tray area.
I installed my drain plug, trim tube, and seald every seam in the tray with 5200.
Got 90% of the engine compartment done with carbon, also reinforced the hand pole area and up toward the nose.
