Roseand's first AM hull build :)

[Schmidty721]

man that looks like a PITA to piece that plug together! Interested to see the final product

 

[Lumpy]

College stole his money.........

Probably isn't far from the truth

 

[Jakobi86]

Why are they all different colors? So you know what goes where?


Sent from my iPhone using Tapatalk

 

[Roseand]

Why are they all different colors? So you know what goes where?


Sent from my iPhone using Tapatalk

Pretty sure they ended up ordering a bunch of different filaments and they were all different colors so they used whatever they had at the time. Not sure exactly.

 

[Nate_D]

No promises, but I should have mine before the end of the month as long as there aren't any snags that come up.

The CAD model looks awesome and I can't wait to see the finished product!


Sent from my iPhone using Tapatalk

 

[Jhucke]

I'm excited to ride this thing. Pretty curious about your motor setup too!

 

[Roseand]

This was just leaked on facebook, so I'd say it's safe to post here

 

[sneds]

Looks great!

 

[vshockey10]

How long has it taken to print the mold?


Sent from my iPhone using Tapatalk

 

[jackmarcus]

The top deck looks really tall


Sent from my iPad using Tapatalk

 

[Big Kahuna]

The top deck looks really tall


Sent from my iPad using Tapatalk

Yeah, but when you look at most back flip hulls you will see a 3 to 4 inch foam block under the pole. So if your hood is taller it is not messing anything up.

 

[Roseand]

@jackmarcus

Compared to most hulls I wouldn't say the top deck is too high. The hood is so thin as well, so keep that in mind. The hood isn't a few inches tall like alot of other skis.

 

[bonsy17]

Super cool to see a hull being built off of cad and 3d printers. I got to mess around with some of that when I was in college. Actually built part of a single cylinder engine that u can turn the crank and move the piston up and down on a 3d printer. Hopefully ill see u at the dells with my chopped up sn finished too!

 

[Roseand]

Super cool to see a hull being built off of cad and 3d printers. I got to mess around with some of that when I was in college. Actually built part of a single cylinder engine that u can turn the crank and move the piston up and down on a 3d printer. Hopefully ill see u at the dells with my chopped up sn finished too!

Absolutely man! I'll trade ya for a ride on the chopped up square

 

[Roseand]

So I'm going to a lighter hull, a ported motor, and a bored nozzle. Is there a good chance I'll have to repitch from my 9/15?

 

[IS0LD0UT]

Doubt it

 

[bonsy17]

I dont think so either. I will be running a similar setup just probably not as light of a hull and plan to run a 9/15. I have only heard of people going to 10/16 hookers when they get closer to the 800cc motors

 

[Schmidty721]

I have a 9/15 & 10/16 hooker here. If I handed you the props with a set of pitch gauges and had 10 people look at them and tell me which was which I bet the results would split right down the middle.

 

[Roseand]

Good to know..

I'm stuck between ordering snow camo or black and white Diamond turf...

 

[jo5hi3]

i ran a 10/16 behind a jm ported 701..... but i also ran an 11/17 behind an old school 850... so my props are always very odd...