DarkWater
Down Side Up
- Location
- waterford, MI
Super Jet Sluggish solas mag
- Thread starter Poizen
- Start date
- Location
- Grand Rapids, MI
Wow.....skills!!!!
let us know how it worked for you.
let us know how it worked for you.
- Location
- South Africa
Thanks for kind words guys
Just hope it all pays off
Just hope it all pays off
- Location
- Grand Rapids, MI
Just like boring the nozzle I found a stubby cone to be a good tuning tool. Definitely worth a try. Some people have good success, some don't.
Nice work, now find another nozzle and bore to 84-85mm for a noticeable increase in low speed thrust. You can use your lathe if the siphon is removed or a mill/turn table if left in place. I have never had any problems chucking the inside flange so long as the cuts were small.
Last edited:
- Location
- TN
Nice lathe work man.
Sent from my SCH-I510 using Tapatalk 2
Sent from my SCH-I510 using Tapatalk 2
- Location
- South Africa
Just to give a updated tested it with the new stubby and it's so much better now I can go on the mag pump hype loving it brapping
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
Nice work!
I would have taper bored that reduction nozzle to a larger diameter with a 3-degree angle and cut that siphon tube shorter.
I would have taper bored that reduction nozzle to a larger diameter with a 3-degree angle and cut that siphon tube shorter.
- Location
- South Africa
- Location
- South Africa
We can chat