Just pull the blockoff plate back out put a light coat of gease on the oring and reinstall should be fine! And shim your back two bolts on your ride plat with two m6 size washers you should be good to go!
Sent from my iPhone using Tapatalk
Im looking for some main and pilot jets for a single cdk2. Paypal ready . Need an assortment if possible 155-145 mains and 80-90 pilots.
Sent from my iPhone using Tapatalk
That hole will not leak water in while the ski is running no matter how high it is in the hull. It just allows enough air to siphon from the bottom
Sent from my iPhone using Tapatalk
Im planning on running a single 46 on my bp 750 with a milled head and drypipe. Im not sure where to start my jetting at. Anyone running this combo?
Sent from my iPhone using Tapatalk
Need help with a baseline jetting to start with. I'm running a single SBN 46 carb and I'm not sure where to start with the jetting! Motor is gasket matched 175psi per cylinder with the pipe no timing changes only water injection setup on it. Any help would be great!
Sent from my iPhone using...
Not sure if you have gotten this problem solved or not but opening the screw on a two stroke will make the bog worse. Most bog will come from to much fuel. If you started at 7/8 i would go to 3/4 then go from there. Put a new set
Of plugs in and warm it up then check the plugs. If there oily...
Yup but dont tighten it really tight then back out 1 turn and go from there. Use your plugs and throttle response to tune it. I/E read the plugs. Good luck!
Sent from my SCH-I545 using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.