Search results

I went to autozone looking for their rebranded etx9- They have them at $119. and now only carry a 6 month warranty from date of purchase.... My 2 old SeaVolt ( deka ) lasted over 6 years in my blaster and Kawasaki. This last ETX9 I bought lasted about 9 months.

Victor was overseas and they couldn’t get his race boats there in time. They had to throw some make up on a round nose superjet.

There is way more to it than this ^kit you posted above... none of that is bolt on and go. There are so many other mechanical factors at stake. As well as you still need to build the water cooling element and adapt exhaust system.

unless you are looking to build a stroker motor with gas valves and sled cylinders.. There are not a lot of options for the domestic twin Polaris. You can use the 70mm crankshaft that came in the octane and the same 800-1200 cylinder jugs. They can be ported and improved by a few engine builders...

Following this thread as well. I have a V1 and my right rear motor mount looks the same. But mine looks to be filled with the same resin laid up thru the whole Hull. I have a Jet Dynamics Alum pump shoe I am working with on mine. Can you post pics of the shims you made up? I had washers on the...

@E350 I'll chime in, I installed my tom21s a few years ago, On my fx1 I installed his OG design without Bolt holes. That being said, The fx hulls are all hand laid and can vary from hull to hull, add in the fact his sponsons are hand made and back filled with foam.. There will be a lot of...

Fixed Fx1 That was Redwood's ski from Ontario. I remember seeing it when it was just finished.

RadDudes used to sell a conversion plate on their website. They might have one laying around?

Finnegans Garage 2022 Yamaha Jet Blaster

check the splined end of the drive shaft and make sure the rubber isolator( bumper) is not jammed or wedged into the impeller nose. the isolator fits into the tip of the driveshaft end. you should also double check your pump alignment and pump seal against the pump shoe . Both my octanes have a...

same as a umi or ada setup. PM Jetmaniac

if you already have a tube in the hull for a cable or extra cooling line you can use a rubber boot with a reducing end. Thrust innovations has them or check with jetmaniac. If you have no trim tube you can try searching and looking into a cable gland fitting. installing a proper tube thru the...

Injection setup

Holy Bat Guano Batman!.. Look Over there, Its Brapperdoodles and another project ski.. Robin, my dear caped companion.. Lest your eyes do not deceive you .. That's no project ski, That Looks to be a Resurgence of the FxMafia !

I have tubbie 2s, ProWatercraft and tom21 sponsons each on of my 3 skis. The Tom21s are on my fx1. They are thicker than the prowatercraft units and shaped differently at the front of the sponson. Mine were also foam filled on the backside whereas the PW sponsons are solid material. ( I did have...

What’s that price on those portable storage bunks?

Xmetal std length adjustable pole, cold fusion lowered pole bracket, wet racer front hood hook, rrp 50mm riser bars on an ADA turn plate. The pole really follows the hood line and sits low under a cover. I don’t have a build thread as i re did my fx years ago. I suppose I could make one. I have...

Virginia here, I’d like to meet up with some fx1 Brethren at wavedaze or make it down to a southern fried free ride if I can get some time off this year[emoji1308] maybe we should refresh or reactivate the fx1 owners list. I met a bunch of the Fxmafia ages ago at a couple VA Beach freerides. I...

Try this at the paint store or if your having a shop spray it, they should get close. This fx1 was redone a few years back.