Search results

After everything it may have been a bad set of plugs.... Lmao

Anybody have a front exhaust outlet?

Haven't worked on the ski on a long time but got back into it this week. Decided not to to do much with the nose but make it pretty. I ran new air duct in the hood and sealed it off. All glass work is pretty much done just time to make everything look good!

Well dry pipe it is. Any body know what type of pipe it is? I need to get the bracket to attach to the ADA Head ASAP!

Ok I'll give steve a call

So looks like dry pipe it is. Anyone have the mounting bracket for an ADA head

Thanks man. Now thou think it would make better low end as well. Thats where I'm looking for it. Is it a riva dry pipe that I have because I have seen riva dry pipes that are a lot smaller

Here's a picture of the dry pipe I have

Where was the red pipe coming apart from. Mine is from a blaster that I cut and welded straight. The manifold bolts to the rest

I have both a riva dry pipe and a riva red pipe. What pipe would be better for the surf. As much low end as I could get. 62t/61x engine and a ada head 35cc domes

Heat shrink tape

Yes let me know how that works out. I have my scuppers coming out the side like yours and have Tubbies so putting it out the front may be difficult.

I have a full electrical setup from a 650 motor if you're interested. Should just have to swap your rev limiter and you're good to go

Have you had any experience with having the outlet right by the bulkhead. I want to do that with the build I'm doing now but scared it may cavitate

Subscribed! Thing looks awesome. Whats your concept behind the wide rails?

If anyone's still interested. Both scuppers are in. Going to test them later and make sure nothing leaks. Also gonna put the ski in the water and see if it floats!

I want my squarenose build to come out like this! Awesome job man

The ski sat in the water for over 5years. Salt water even better

Prop wouldn't come off driveshaft either

At least it didn't stay with the prop