Search results

I am looking into getting a KP pole for my Backie Chan and was wondering if anyone has a suggestion for what length I should start with? This is my first A/M hull so not sure what would be a good length to start with, I know I can always shorten it later. Thanks

So instead of starting a new thread figured i would just ask this here. Just picked up a B-pipe and it came with a gasket kit. I think the gaskets are for a 61x but am not sure. how can I tell the difference between a 61x gasket and a 62t gasket?

Looks good. Curious to hear how it rides.

Thanks for the info. Good to know that I will need the 62t gaskets and if i get a 61x I will more then likely try and port match it.

Alright, that should be easy enough. Thanks

Recently picked up a 760 raider to use as a donor ski for my backie chan. just started looking for a different exhaust system for it and was wondering what exhaust systems will work for this? Did some searching and didnt find any info that really helped. Would like to get a factory pipe but I am...

Sweet project, have always been curious what it takes to convert to a fixsteer.

only con I know of is that they are a little more work to get up on after falling in deeper water.

any suggestion for what I should try for pop off pressure? I know stock is 55psi and mine is at about 40-42psi.

I have been trying to figure out what is causing my problem with no luck so far. The ski starts and idles alright but doesnt have the acceleration it used to, seems like it still has a good top end. I rebuilt the carb and put in a new needle and seat and rebuilt the carb, with little change in...

Just wondering if anyone has some suggestions on where to get a replacement hood seal for the FX1. Mine is pretty much toast and I should probably replace it. Thanks.

sweet build, when are you going to put the Handle pole on?

I think it was around $85.

No experience with either of those but I got my fx1 cover from Covercraft and it seems to be very well made and fits good.

A couple of them did go all the way through, which is the main reason I was concerned about it. Thanks for the help.

I had to remove my bilge pump to pull the flywheel off and I noticed that it was attached with screws that went threw the bottom of the hull. Also noticed that there had been previous screw holes that had been filled and when I put a light over it you can see the light threw all the previous...

I ride in the detroit lakes, mn area usually. Since those are the closes lakes to fargo. I believe it is the stock pump still. I havent done anything to it since I got it.

Looks like a fun project. Cant believe how cheap you are building it for.

figured I should share mine as well.