- Location
- WI
@JetManiac do you have this extension piece?
"Budget" KDX Build
- Thread starter Skirunner24
- Start date
Byeai
"Cheetos-Man"
- Location
- Melbourne FL
U might be able to make one also from ace hardware
Sent from my SAMSUNG-SGH-I337 using Tapatalk
Sent from my SAMSUNG-SGH-I337 using Tapatalk
- Location
- WI
Is it just a threaded tube extension?
Byeai
"Cheetos-Man"
- Location
- Melbourne FL
Basically yes and a ball joint but hardest part is finding metric ones
Sent from my SAMSUNG-SGH-I337 using Tapatalk
Sent from my SAMSUNG-SGH-I337 using Tapatalk
- Location
- WI
Flipped the stator. Alignment looks good now. Found two more stripped pump inserts though...more helicoils. Fuel lines plumbed. Cleaned and painted nozzle. Just need to fix the inserts this week and I should be back in business...
Byeai
"Cheetos-Man"
- Location
- Melbourne FL
Did u end up getting that extention
- Location
- WI
Got it ordered from JM. Should have it tomorrow. Gonna be a busy wkd!
- Location
- Nashua,NH
Bring it to wavedaze trent
- Location
- WI
Won't be ready by then...Next year!
- Location
- WI
Been making some progress lately. Motor, electronics, pipe, tank are all in. Pump is finally in. Pole is on. Steering is mounted. Unfortunately the rrp bar clamps don't fit the fat bars I had. I have a nice rrp bar from my old setup that I can run but I need clamps that fit that standard size bar.
Anyone got standard bar rrp clamps???
Anyone got standard bar rrp clamps???
- Location
- WI
- Location
- WI
Byeai
"Cheetos-Man"
- Location
- Melbourne FL
Just buy fat bars they are nice
- Location
- WI
I'm not sure what size these clamps are at though. From what I understand they were bored out already by #zero to some off size to fit mountain bike bars?
- Location
- amarillo ,tx
Are they 31.8mm?
- Location
- WI
Not sure... The bars are 35.0mm and they aren't even close to fitting. It could be...
- Location
- amarillo ,tx
Ill check when i get home, ive got some bars i was gonna use on a wdk big dawg steering,
- Location
- WI
Cool...thanks!
CD155MX
Squirrel!!!
- Location
- Alta Loma, CA
31.8mm used to be the biggest diameter mountain bike bars, but now 35mm is another size that is out there. I don't think the WDK steering has provisions for 35mm though. Probably just the 31.8.