- Location
- Lodi
Well today I finally finished my 760 superjet build, it has a blowsion head pushing 200psi, dual 44's tuned by ski clinic, b pipe, msd enhancer, the waterbox and some other nice parts, I was riding it for only 30 minutes and man it ripped, the ski loves getting big air out of the water, I am new to superjet and started learning some good nose stabs, I was getting pretty inverted and I got almost upside down on one and landed sideways in the water. It snapped my pole and at the same time it snapped my start stop switch and pinching the throttle cable wide open! The ski took off in a straight line down the river and made it about 75 yards before hitting the bank and going airborn about 15 feet high, I watched this happen while my friend on a 550 chased after it to shut it off, he tried to hit the stop button un aware of the snapped switch and nothing happened so he jumped back on his ski and ran back to me yelling "I DONT KNOW WHAT TO DO" I then jumped on his ski and rode to it and jumped off of the ski on to the bank and hit the stop button, still nothing, then I picked the pole up and it took the stress off the cable, slowing the ski down to the an idle, I then pulled the hood off and ripped the spark plug boots off which thankfully killed the ski, how the ski lasted a little over a minute wide open I do not know, people came and gathered around while I was really pissed off at the hole situation and YES I WAS WEARING A LANYARD, the switch broke before the lanyard got pulled out, some guys on sit downs came over and offered me a tow back, they pulled me to the ramp and I got the ski in the bed, I took it home and looked at the damage
-cracked fiberglass up near the gas cap
- bottom of hull has nice big cracks
-both couplers sheared into pieces idk how
- probably melted some couplers or gaskets
So here is what I want to know, do it guys think that motor will be ok? Should I pull he head and install new o rings, that's what someone recommended, I was planning on picking up a hurricane hull in 2 days fml
Now for the carnage
-cracked fiberglass up near the gas cap
- bottom of hull has nice big cracks
-both couplers sheared into pieces idk how
- probably melted some couplers or gaskets
So here is what I want to know, do it guys think that motor will be ok? Should I pull he head and install new o rings, that's what someone recommended, I was planning on picking up a hurricane hull in 2 days fml
Now for the carnage