Search results

The Reason was THE STATOR, even though it was testing good. I sent it to John at jet ski solutions to get it refurbished - I tell ya it came looking new and working better than new :). thanks John. He said it tested fine without running also, but once he had it hooked up to something it was a...

Reason was THE STATOR, even though it was testing good. I sent it to John at jet ski solutions to get it refurbished - I tell ya it came looking new and working better than new :). thanks John. He said it tested fine without running also, but once he had it hooked up to something it was a...

I copied this from a different post. "Another interesting point is the "sparks when you let off the start button" syndrome. This always means on of two things......the cdi is bad, or the pulser coil is bad, or the wire from it to the e box is open."

I rotated 2 white wires no change.

I followed these instructions. http://www.x-h2o.com/threads/21086 I just replaced protec with spanky new msd, the protec had the coil ground. Msd doesn't-Is that ok? Single spark appears when i stop crankin same on both spark plugs. Any suggestions? thank you I should add - it...

In order for me to check the spark would be on the flat water, Lake Michigan doesn't get too flat. I am going to replace my fuel filters, and cdi I 'llkeep one the side.

Everything tested within the range , except the "lighting" coil (or rectifier), But according the the link it causes the battery not to get a good recharge. I am replacing it, any suggestions who I should order from? Will That FIX my problem U think?

there r 5 wires coming out of the stater. How do i check it?

I wonder if this pink wire should be connected to the loose black ground. But it was like that when it ran i guess. I guess i am ready to check the stator.

I just got done checking s/s switch, the digital meter was reading fat 0s, and 003.

Man, i really appreciate the quick suggestions Thanks again The new ign coil came with wires, and boots. Got it from Jetski solutions. -The carbs are ok i am sure. -The s/s swith, i assume it is start stop switch. If it is the case, Is possible to cut of one cyl 1st? What am i looking for...

sj with some mods on it, my compression is 170 Out of the water sounds great. however, when i take off the front spark plug boot off while running it takes 2 to 3 seconds to die out, when i do it on the rear it dies out instantly. after about 30 seconds to a minute in the water one cylinder...

thank you,

I'll just have to deal with this problem, but I am happy that there are so many people willing to help me. Please DO NOT RESPOND TO THIS THREAD!!!!!!!!!!!!!!!!!!!!!!!!!!!! it's over with i'll live.

that's right, it was my fault for not knowing about letting off the throttle when up in the air. But, i spoke with Brian (really nice guy), i remembered that when i was up in the air it was loud alright, but awful grinding noise too. Is there a part out there that will survive the full...

Hey sjetrider, I send you pm with my number please call me. All I am asking is "What did I do wrong here man? What U all think this is going to cost me if i take it to the shop. I need to keep riding this season. I am not trying to point at anybody, it's just sucks for the 1st timer to...

the pump came unhooked, nice. Would you mind telling a ball park figure on this. Thank You,

u think i should do it with in 24 hrs of the incident or i got till Tomm

1st time riding a stand up, and should say i got used to it pretty quick. I took under water a few times with pump on at that point i was pretty beat so i took it on the straight away and just gave it all had and that's when this happened

1st of all I am not trying to blame anybody for this, especially when sjetrider has good reputation. I am just tring to get advice, becasue this boat f...ing riped for 2 hours. And then when this sheddered, yes it took water like crazy. There is no whole on the side, it's send. Let me know...