Search results

You probably can send it to blue here on the x as well. He is in fla. so he is close. He rebuilt my jetworks 850 and did a great job with good turn around.

Can't seal polished concrete. Can't even wax it.

Yep. I did a garage for a client that wanted partial flake. Never again. He slipped and hurt his arm and his daughter slipped and almost broke her leg. I went back over there with a 100 sanding screen and my floor buffer. He was a lawyer too!

Looks great!

Got the electronics finally swapped. This time I let it sit on the beach cart and run a bit. Lo and behold,water skeeting out the side of the head on the carb side. So after tightening to the point of stripping out a couple of bolts,heli coiling adding a new gasket....same thing. I have a stock...

I have it jetted lower like my SJ. If not smaller jets! CPT ported all 61x Tried 115,120 and 122.5 low all same results 150,145.5 highs same. Cut back plug wires,heat sensor delete,new diaphragm in carb, tried new 2.0 needle and seat from the original 1.6. Changed pop off several times from low...

Checked everything. Reeds look great.

I can not for the life of me figure out what's going on with this new engine. It absolutely will not plane out. Acts like it is WAY rich. I have gone through everything and can only speculate that it's the head I have on it. West coast with 650 domes. Was told when I bought it that it came off a...

I am having a time getting the jetting for a simple set up. I had an intake lying around that I ported years ago and stuck it on the new motor I built over the winter. The ski seems to be rich as he'll to the point that it won't even plane out I have a 120 on the low jet and have changed pop...

Are you going to become the new Gil and do vids on the new carbs!

Probably has a clog in the one that's is open. Need to remove it and flush it out.

https://www.amazon.com/gp/aw/d/B000Y8YEMI/ref=mp_s_a_1_5?ie=UTF8&qid=1497365644&sr=8-5&pi=AC_SX236_SY340_QL65&keywords=1+inch+hub+tires&dpPl=1&dpID=51owe4NfRfL&ref=plSrch#

I got mine off Amazon. I will see if I can find as link but if you search you will see the same ones. I have to say I do like the ball in tires better if hauling a ski on gravel etc. The tires I have do not provide the shock absorption I need so the ski tends to bounce around.

Only the uneducated ones from Florida! ;) They must have taken a Soros train to get there.

The better question is, what is the desired temp for the V3!

Seems like you should be able to go to a trade school and maybe recruit a young guy that has talent and wants to get some experience.

You deserve a vacation!

Always liked Cleveland.....even more after leaving the ex wife there!

Well poop! I have my b pipe from my lay down swap lying around so I figured ,hell I will just stick that on and get a blaster chamber. Took everything off ,got the mani on and BOOM the head pipe doesnt fit into the hull. Hits the side. At first I thought it was the foam crap and that it needed...

Thats what I was thinking. It doesnt feel or look aluminum.