Search results

where does the plastic snap ring go? In the little groove behind the bigger rubber piece on the cable?

I am installing a steering cable and am having trouble figuring it out. There is a rubber piece, a plastic washer that comes apart and a metal washer. What order do these go in and where do they go on the cable? Does anyone have any pictures. It seems the way I installed it that it doesnt steer...

I have a 62t/61x motor with an ADA head with 35cc domes. Also I have a b-pipe, what size jets should I go with?

I have a superjet pump and a skat trak prop I dont have the washer for behind the prop. I put the prop on hand tight and it doesnt hit anything. Is this alright or should I get the washer?

Do you know what size the handpole is? Is it shortened? and would you take $200 for it?

I have a 62t motor out of a wave venture I am putting in my superjet. I want to get the cylinders ported for freestyle and I was wondering would it be better to get 61x cylinders and port them or port the 62t cylinders?

I have a 62t 701 out of a waveraider. I was thinking about getting the cylinders ported. Where is a good place to have that done.

I have a 1990 squarenose and the stop button on the start stop switch doesnt work. The tether also doesn't shut it off when removed but it wont start without the tether in. I took the switch apart but didnt see anything that looked corroded or broken. Any ideas?

should I try a whole new set of electronics

I put a different stator in

do you think that the wires rubbing through on the flywheel shorted something out and messed up the CDI and then when I switched CDI's it messed that one up too.

but I switched carbs with a set there were all of the stock settings and it didnt change a thing

it has 140 even compression so it shouldnt be a head gasket right and would the waterbox baffle make it run bad like that?

did it run good out of water

Im pretty sure its not plugged in at the ebox.

yea it has bigger jets in it but I switched carbs with my friend who has the stock jets from a 62t and it did the same thing

I have a superjet with a 701 that I put together. The motor was ported and the head was shaved and it has a pro tec pipe. When I first took it out it ran good for about 15 minutes and then it would not get full power. I tried lowering my pop off that did nothing. I switched carbs with my friends...

I took off my flywheel cover and there was oil in it. It smells and looks like motor oil. Does 2 stroke oil eventually look like motor oil. I dont think the crank seal is leaking it looks good but theres a bunch of this oil all other the stator and what not is it supposed to be there or do you...

what has to be done to put a girdled head on a 62t cylinder

I read on the Jetinetics website that their flywheel doesnt fit 62t cases. I have a 62t motor out of a waveraider. What would be the best charging flywheel to get and where is the best place to get it. Also would a girdled high compression head or a lightened flywheel make a bigger difference in...