Search results

Still on the hunt

I have two sets of 44mm Buckshots. One with standard flanges, the other on spigot mounts. Was asking $350 per pair.

Do you know the length? I’ve parted a few, among other old Yamahas

Bump

Not to derail, but I can see from here that there are several ounces he didn’t remove, nor do I see signs of balancing. But good luck with the package sale.

What makes that the best flywheel?

Still looking

Definitely don't spend $800 for an aluminum flywheel. I charge $75 to lighten oem 61X or 62T flywheels. Use the extra $700 somewhere else.

Sent you a message last night...

**Found a chamber. Looking for a water box, now. I do have a TNT waterbox I can trade for a smaller PFP-style one. Who’s got a cracked Power Factor chamber they need to get rid of? Would also consider a TNT. Don’t want a perfect PFP, because I’m going to cut it open anyways.

You will set the static angle based on where your pickup plate is set to. I suppose you could set the cdi to 42 and then adjust your plate to match, or you could set the plate and adjust the cdi static angle to match. My MSD was set at 32 degrees. I put the MS01 in and set static angle to 32...

Did you try bypassing the module altogether?

Obviously, but I swore I had an ignition issue the whole time.

You know, I spent all summer chasing MSD problems on my ski, throwing parts and time at it. Turned out to be my fuel filter was bad and would run fine for a minute of two, then start restricting flow…

Try OCD Solutions . He has a dynamic bench test setup.

Bingo

I don’t know where to get a new one, but I can pin the gear you have. Maybe rotate it 90 degrees if wear is the issue.

I have nice 64X cases, in virginia…

Bump. I think some WDK engines need this…!

PM sent