Search results

If I recall Rage's Havoc build thread, they lowered the tray, but left that step in there for the midshaft housing because they couldn't lower that any more and have it align properly. That step is the same height as the 25mm pad, so when it's turfed you don't see that step any more.

Better yet, just fill a grease tube full of epoxy resin and pump that in, it will be waterproofed forever!

The red wire in your epic looks frayed too

It goes to the top starter mounting bolt.

ustream.tv/surfrat Says the reveal is tomorrow at 8am.

I've had to warranty a couple myself, but haven't had any issues with them not honoring it. It's always been due to water intrusion. Apparently WPS makes a waterproof case for their lithiums.

That line is supposed to have a vent valve in there. It's a one way valve that allows air in, you wouldn't have any pressure in your fuel tank without that vent valve.

I'm thinking they just sat the TNT chamber in like that, took a pic and posted it as a joke. I saw that too and thought it was a pretty good joke.

Maybe get an empty caulk tube, mix up some thickened epoxy and fill the whole crack with that while trying to inject some in the crack as well?

Are you running race or pump gas?

I'm getting 24.50mm (0.960") ID and 34.70mm (1.363") for the OD. 2.95mm (.113") thick.

It doesn't say, but I would guess it at around 2lb. It's definitely less dense than the 4lb foam I have.

No, it's called Sikaflex Post Fix.

Home Depot sells two part foam, look for it in the aisle with cement for fence posts. They're using waterproof two part foam to secure fence posts these days instead of crushed rock or cement, it's made by Sikaflex.

That's pretty short notice and weird that it's on a Wednesday...How many skis are expected to show up?

@JetManiac has them

Just got this in the mail today, excited to try it out.

You should get some empty caulking tubes, thicken the epoxy to peanut butter like consistency and then inject it. Would be way easier than trying to use that tiny syringe.