Search results

Go to a store that sells string trimmers/weed Wackers/hedge trimmers etc. Ask for a box or for them to save one for you. Shipped a couple pumps that way. Pretty positive the stihl ones even have a center section that holds the driveshaft up like it's meant to be. String trimmer box you'll most...

Went to clean up some cases I bought and discovered this. The area is still recessed some even though it's hard to tell from the pics. Is this going to be an issue? Worried the oil could roll off the backside instead of making it into the hole.

Anybody?

BUMP these are for any manifold using OEM reed bolt spacing. OBO

Looking for New WSM, New rebuilt(not sbt) or New OEM Lemme know whatcha got. Thanks!

Looking for one before I send one out to get done. Thanks!

Or if all else fails nail it with some compressed air. Will make it either easier or harder to find lol

I've had the exact issue on my rip a couple times. couple options.. If the zip tie is small enough you can punch out the roll pin and slip the zip tie through the hole and then replace the pin/ball. Otherwise.. Push it through the rear with a long screwdriver and pick it up with a long needle...

Definitely don't run a pole spring. Running the pole tight will provide much needed back support and prevent fatigue and make riding easier...

Bump make an offer

I'm glad the 17 without the backer ended up working well for you ;) I'm surprised not many use it.

Bump for Rad valves for your yamaha twin or triple!

Anybody have one of these??

Bump

@yamanube

Pm sent

I put a heat gun on it for a few minutes, then the epoxy was soft enough for me to stab it with a screwdriver and it broke away with ease. Completely debonded from the aluminum so it is nice and clean! Thanks for the advice. And yes, it definitely stinks!

Brand new. 300 shipped for all 3

I have an intake manifold with the crossover filled that I want to redo. Is there a solvent I can soak it in to soften it/Debond it? Heat? It's an oem 760 manifold so if I have to grind it out I'll just pickup a new manifold. Just seeing if there's an easier solution. I believe it's either JB...

What the heck are you talking about?