Search results

Is it really overheating? I'd use a heat gun to verify what the temperature of the head & cylinder are and also verify the temperature of the exit water.

While the wires are cut add a water proof connector rather than splicing them back together. Sure makes it easy to remove engine or the ebox with out removing them together.

Sold

I'm no battery expert, but this is what Taylor put in our Rickter in 2016. It's still going strong 4 years later. https://www.amazon.com/gp/product/B00I1KMO0K/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

ttt

sold

It's a real thing for some skis. I installed the premade insert in our FZS when we started hitting speeds in the 80's. It's not a fun job, but much better than dealing with a crack in the pump tunnel.

TTT

Selling a RRP chinpad. It's black carbonfiber and comes with the brackets and bolts to mount it to a RRP pole. I believe it might fit an SJ too, but I never tried it. It's in great shape with only a couple small scuffs or marks on it. Note: The photos look funny because of the reflection of...

It's off an 08 Superjet, all stripped and ready for final sanding and new paint. No cracks or repairs. No hardware, hoses or storage compartment included, what you see is what you get. It's going be expensive to ship, so I'll do $175 shipped to the lower 48 states.

Yes double ss lock nuts with some G Flex over that. Re-enforced that area when re-foaming the tray. Backing plate on the U bolt underside of hull.

I have pretty much the same padding. I just put a bow eye U bolt under the tray. Works great and the nuts in the tray are easily covered by the thick padding, you can’t tell they are even there under the turf.

Helmet Gloves Shorty Wet Suit for Protection Ride near shore, not in middle of lake in case you have a problem. Don't ride alone. Little fuel as possible to keep ski lite. If you have bilge pump turn it on. As others have said, Never Let Go

I'm checking the reeds too. The oil in tank is mixed with gas, hard to tell how much. I'm cleaning out tank, lines and new filter. Remember he drained the tank (as best he could). I think some of the gas evaporate giving it the extra oily look. Question; If the check valve on the tank was...

Well the seals are fine, he didn't really pack them, but he "greased them up really good". I went ahead and pulled the head pipe off and pressure tested the cases. I holds 10 psi for 45 min before it dropped to 9.5 psi. I then turned it over by hand a few revolutions and it held firm at...

Ok will do, thanks

I'm not sure, I wasn't the one that replaced them. I can ask him, are you asking if the old ones were packed full when taken out or are you asking if he packed the new ones when they were put in?

Oh, that plug. It was the rear cylinder. Engine was rebuilt 2 years ago with new Yamaha seals and held pressure great at that time according to the owner. Doesn't mean it's not leaking now, so I should check that too. Does anyone run richer jetting in the rear cylinder of an SJ, like the...

I’ll check everything mentioned. Thanks

White plug? Are you talking about the camera reflection on the piston tops?