Search results

"Sometimes"........... lol

I have replaced these without cutting out the whole tray. You can flip the ski over, and cut a square out of the bottom in that area. You will then be able to hold the nut on the inside, and remove the cable holder. Install new, and then glass back up your square. I kept the piece I cut out...

The pipe should slide into the manifold. It should have large o-rings to seal. The coupler just holds it in place. "IF" there is any gap, you will just blow the coupler.

You CAN do it as Fact pipe describes in their instructions. I just prefer to fill the pipe from the bottom (Back of head pipe) as it pushes are out as it fills, and IMO water line routing is much cleaner/easier. Fastfairlane has another good option as far as routing goes. Many times we also...

No.

Pole will bolt right up. Steering will work with your stock 08-later cable. We have a quick steer system specifically for the gen 4 pole, that you could use, and again keep your stock cable. IF you change to the 07-earlier cable you will need to find or make a cable mount adapter.

Same here....

Here is a video I did a while back discussing impellers;

Looks like you are in MI? (Elevation will make a difference on impeller recommendations) I would go 10/16. IMO 9/15 is going to fall flat in the mid range. Especially with a 650 exit nozzle. I would NOT combine a 650 nozzle with a stubby pump cone. The short pump cones allow the water to...

t appears It appears as if your domes have been cut. You can measure the CC's of the dome to determine size.

I think the KP is an RRP copy. On an RRP we use a std RN pole spring. I have used a SN spring. We cut the ends off, and run it upside down. I have springs in stock as well.

We use either OEM or RRP poles when we do conversions here. I am not familiar with the KP poles. It should work as long as they are a std RN pole dimension where they mount.

Our bracket is not a "hazzard" bracket. That is a member here.... With a RN pole, the stock pole lock does not work, if that is your question.

NEW Carbon mix EME Roid hull here in WI 53545. Will give you a great price if you want to drive over with CASH. White with black graphics. Comes with hood, pole mount, foot holds, pump shoe, ride plate, hood gasket, hood strap, graphics, etc. Weight is aprox 70lbs. They ride great, VERY wide...

As said, you will need to swap to a SJ (61x) head. Also you will need to port match your exhaust manifold. Use your 62t gasket as a guide to raise the ports on the manifold. BE CARFUL to not go too much, as you need some sealing area for the gasket. The 62t engine is our favorite.

I have everything here, and we ship to Canada. New or used carbs. Used flywheels good, used wear rings New engine mounts. Also have pistons, rings, gaskets, crank seals, case sealer, can do machining for you if you want to send your cyls, etc. Best to call my shop. All of my contact info is...

Our original RCJS Pole bracket in stock here. Works with your stock SN pole bolt; https://watcon.com/products/handle-pole-conversion-bracket

Sold, thank you everyone.

Used, Blowsion billet SN SJ Handle pole bracket. Fits all 1990 to 1995 Yamaha Square nose Super Jets. Sold as is, as shown with pole stops, and hood hooks. NO RETURNS. Please email with questions before ordering. $150.00 + ship Thank you...

Ok, sorry as I "assumed" you had a 701 of some type. 760 is different. I am going to respectfully bow out here as I am really unfamiliar with build at your elevation, and do NOT want you thinking what I say here is good advice for your build. You need to learn about reading piston wash, and...