Search results

@BruceSki has been running 33 cc domes on pump gas for a long time as long as your jetting is enough. I've run 35 cc domes on 83mm bore @ 205 compression on pump gas no problem.

Holy bust your chin and teeth on a ski Batman ! Have you ordered a 6 pack of mouthguards? Might be a good idea for many of us. What caused you to slip out of the holds ten minutes into the first ride, killing it out there ?

I was very impressed with the M1 at Daytona doing flips in the shallows of 2 feet deep, off of residual surf.

Lower cost way to make decent power for the type ski that uses bpipe ?

Enhancers gone bad give that same symptom. If not that, get the new oem harness/switches only which is less expensive and swap it into your housing/buttons. JM sells them too.

The new oem Kawi coil Roland inspected was NOT tinned so possibly they are not all the same, but it definitely was not tinned.

Definitely win the award on the X (time after time) for creative thread titles, no doubt.

Love those Blowsion springs !

Yep 11.8 volts is about 1 volt too low. Low voltage/amps won't spin the bendix fast enough to engage in most cases. Moisture in front cover making the bendix stick is sometimes another issue but your battery should be investigated. Attached pic shows a extra strong but light battery, notice it...

I have run a Kawi coil with an enhancer in saltwater no problems. We don't know why it didn't work with the TS2.

I know a local rider that initially had low end breakup with a new system that cleared up after switching from a new Kawi coil to a used OEM Yami coil. The Yami coils have tinned wires, Kawi does not. Unknown why this occurred in freshwater only testing but it did. With the used Yami coil the...

Same story here, taking a curve too fast with a dirt bike on a gravel road, wrecked into a ditch. Suffered through the pain to avoid telling the parents deal. Going to make it to Blues ? Heal soon Jim so you don't miss too much surf action !

I was joking about my baby steps to backflips when I use to do hundreds of 180 slides and huck the SJ over me to get the feel of being inverted with zero height. The smiley face didn't make the cut.

I have fw backflipped a SJ with a ported 735, bpipe, solas msg, d-cut and enhancer but I was mostly underwater.

XS900R in SF Badass -4.3 and KDX with 155 skat, pfp, msd tl, 49 FS's/vf3.

Of course welding it is the best repair but I had good results with JB weld on a chamber and it held up fine.

This is a good re-read thread. Bump.

I use bullet connectors on brown n red start switch wires in lieu of oem connectors that corrode in salt and also as a switch for TL brain...works great.

Should be really cheap to ship Helium because I'm pretty sure it helps increase truck gas mileage.

Save your money buy something good or you'll regret it later.