Search results

you can always use a ss coupler for threaded rod edit: and then weld it for good measure also check if the turn plate indeed hits the steering stop and doesn't just stop on the cable and kinks it

better response with type 4 dry pipe, tested back to back, stock to stock with removed baffle, steve wait till you take a spin on martins (my old ski) oh yeah, I thought no mods as you said at innisfil. I told you it would rather be sooner than later, hehe.

all around Toronto within 2 hours drive, that is not to say that you can't drive down (I know, i know, halifax is quite a drive to TO :sad6: )

actually Darin the FSF this past saturday at ipperwash was a not a good turnout, about 20 skis after everyone bailed but apart from minor issues with my ski an almost perfect ride (did I mention it was flat), perfect to finish the season. couple of us were standing and talking in the moonlight...

anyone know the amp pull?

adam = adam ontario = province in Canada:biggrin::biggrin::biggrin:

I can't, I'm demoing my house, the bin is already in my driveway!!!

here are the pics, works fine now, should I clean these with sandpaper or would that enhance the ability to solder together again?

what is the maximum amp draw (should be right on the starter if someone has one out of the boat)? thanks, Adam PS edit. Whats the guage of the wire going to the starter?

i didn't have too much time but I think it was just a loose ground connection but I haven't taken of the cover yet. DON'T WORRY ABOUT IT, IT WOULD HAVE HAPPENNED TO ME!!! ;)

already got my shirt - nice of course take your time we all know that this isn't your source of income but rather passion to keep it running.

or whatever it was called, bring it back please, I got addicted to it!!! thanks Darrin Adam

try load testing the battery, I've had a sealed one show 13.2 v but vent to about 1 v under load.

perfect, thanks tricky

I believe jbeck's friend has them on wife's 650sx, pm him

Hey Tricky, you wouldn't have a picture would you? Umi spring will work I assume? since I have few of those thanks Adam

my xmetal pole/bracket is installed with two bolt (same as on the xmetal's website). To install the spring do you need to replace with stock bolt? Pics anyone? ps. yeah, yeah I already heard enough from smitty to tighten it up so don't try:argue:

damn it I was happy when there was an RN, SN and FX1. now there is SN, RN old, RN new, FX1. Thanks for clearing that up Adam

ok, I guess thats the same difference as between the SN and the old RN then, right? thanks, Adam

so apparently the 2008 is an inch shorter than 96-07 but ends are the same so with a shortened handlepole by 2 inches there is no problem, right?