Search results

F A W K ! ! !

I've run 37 gallons... I don't know what that equates to in hours though. When I rebuild my motor and pump this offseason I'll also invest in a PET 2000. 0 hours.... that blows! Whats up with Hawaii and ski's?

I've never had a problem with the quality of parts sold there, but then again I'm looking at Kawasaki parts ;)

I like to say their over - engineered to begin with...... :D

Last week my 89 suddenly lost spark. Checked the pickup coil and it was fine. Had power at the ebox but it would only fire at the end of cranking when I let my thumb off the start button. I knew the bearings in the starter were going bad and it was pulling more electrical load than normal. I...

Shortblock = Cases, crank, topend, pistons, and head. Longblock = Shortblock plus all ancillary components.

Sometimes it's easier to ask for forgiveness than to ask for permission.

If your looking for someone to do it for you then I would contact a boat yard that does fiberglass repair. The repair process with SMC is the same as fiberglass, it's just Epoxy resin needs to be used. Yep ---> West System Sand, fill, sand, fill, sand, fill, sand fill, sand, sand, sand...

I wonder if Wamiltons is using the poopty Weber motor Polaris used in their IQ chassis sleds? Those motors were/are nothing but problems both mechanically and electrically.

Common sense isn't so common. Life is tough, but it's tougher if you're stupid.

Also, you could build a rack on top of the trailer to carry gear...... dolly, cooler, pop-up, etc.

I just reported it. Everyone go to the listing and at the bottom right there's a "report item" button. Let's get this scammer shut down!

Don't forget the H too.

Feed that troll...... FEED HIM!

Fixed

That hoodie is basically a tour coat. Racers use them all the time for cold water. I don't know about how it would work in December conditions in Cleveland but I think you'd be better off with a good 5/4 with a seperate hood. I use a Quicksilver Synchro 4/3 up till the lakes here in Maine freeze...

Nice weather weeks??? Dude..... you live in SoCal. You should buy a Spark.

I use West System 105/206 epoxy resin/hardener and 404 high density filler.

Needle arm diaphragm installed in correct orientation?

No worries and welcome :) ........ just want to get you the exposure you need to repair this.