Search results

get 10" keel rollers, I load 1/2 my hurricane at super eaze, then the front lands and then drag the rest. I only use one and the ride plate lands slightly passed it and lower so literally locks it in. If you strategically placed 2 or 3 you'd have a scratchless load. Mine is between the bunks...

Well, put on 2 hours since and pulling like a train. Maybe there'll be a TOLD YOU moment, but sounds like the damage is done. Close this up, thanks for all the input guys. I've ran peppered domes before, now it has a matching piston.

Sounds like they are very similar and would work interchangeably, this should be in the books.

If it is the same as a 48mm dasa intake, this is what I use. I'll send you two by mail at no cost if they work, send me $2 paypal 137 Buna-N O-Ring, 50A Durometer, Round, Black, 2-1/16" ID, 2-1/4" OD, 3/32" Width from Amazon

Cleaned it up, cylinders look good, piston and dome got the worst. I am betting the whole screw passed by all the lower danger and wreaked havoc on the top.

Wouldn't you think that if it passed through the intake port, combusted and went out the exhaust port, that would be the end of it. Was such a small screw, it would have either hung out, or blasted through, in which it did. I am pretty much saying, is that I assume that it probably would have...

The results are in, damaged front piston, holds compression same as other. I think it's had 1 hour + running like that, and it's still pulls me into back flops. Anything wrong running it like this? If it's not disrupting function (I assume) then f*ck it right?

I wish, if it wasn't 10hr dasa 1000cc, no where in reeds, made it to the case.

Went to prime my carbs to start before go out today and noticed one plate screw missing. My question, are the reeds holding it, or did it cycle through motor? Checked piston through spark hole, checked compression, everything seems to be okay.

almost looking like it's a kayak, how much that banana weigh? Looks great!

Saw hull in person on Thurs at shop, looked sharp and popped out. Very nice choice on color.

Thanks for the only reply, that's a good reason not to. Appreciate it.

Currently have a working 61x motor and a 760 62t/62t Also have a motor needing to be rebuilt 61x/62t combo. Have all the parts to build the 61x/62t, but was wondering if I should make 2 (61x/62t) combos and make a weird 62t/61x combo. My plan was to make the 61x motor the back up and sell the...

Still have them, make more to order when get low.

My thinking for a fuel gauge would be one step past limited slips idea of tapping of an inline visible tube, but then add an input from there to relay to a digital readout, either realtime when the boat is stable or an average.

I purchased a gallon of PRI-G a competitor of Stabil. The reason I did this is I was gathering all the gas I had wasted over the years and figured give it a try. $100 later, I may have been over my head thinking I would save 12gal $50 in gas with $100 remedy. While it claims to treat over...

Gpr cable??? Much beefier, not running trim though. Pretty sure thats what the blowsion cable is

I've taken so many starters apart and frankensteined them together, tigersharks, kawi, and yama. If i were you, take it apart. The weak point of these starters are the super stretchy o-rings, allowing a little moisture past, equals donezo washington. Pull it apart, make sure the brushes contact...

Dasa 1000cc/Dual 48 Novis/Pfp

Interested in a tank, w/ sight tube and battery tray, what's shipping to 94520 CA