Search results

That would be a 760 64X cylinder with the 6F 00 stamp code and the term 64X is commonly used because the part number for the cylinder starts with this.

Also what is the difference between the [What's New] button and the [New Posts] button in the top left corner or the [New Posts] button just below those links? They all seem to work the same just different places to click on so it would be nice to have one that would include the posts from the...

I use the site quite a bit and the link only shows one page at a time; sometimes there will only be a couple threads if any during the late hours. With the 24 hour post included they're quite a few more pages available to search without having to go through each forum section.

Is there any way you can make the New Posts link include the; You may search for post updated during the previous 24 hours, here search feature? Example: Old Link: New Posts New Improved Link: Today's Posts

Yes the specifications & testing procedures are listed in the service manual with illustration pictures included.

I would start by doing some ohm checks on the trigger coil, charging coil and ignition coil. Also check your power & ground connections. You can download the service manual here...

Interesting project but those HTS-2000 brazing rods were made for small repair jobs and not a structural part that will see a lot of vibration and exhaust pressure. Those rods are made basically from aluminum and a zinc mixture. More zinc is added than with any conventional aluminum alloy to...

Yes the Riva silver color aluminum charging flywheels were mad by RAD and they use small round magnets which will through the timing off.

Yes if you retain the magnets and only the battery charging will be affected if the magnets are removed. No.. your timing will be the same spot.

Machine the lip on the outside & the raised spot inside; insert a stainless tube or fill the hole with epoxy depending on if you want the stock siphon bilge intact.

PMs & E-mails Sent. I have most all lightened flywheels in stock and ready to ship.

To be honest with you most people with the MSD enhancer for the yamaha engines just set the stator a few millimeters counterclockwise advanced because the retard rate is only around three degrees total. If you had a programmable ignition such as the Epic or Advent this method and marking the...

Looks good so far... now you just need to make some more timing degree marks on the flywheel or coupler. Also you'll have to covert the metric depth measurements from the piston travel calculator to SAE if your dial indicator is in inches. Yes the stator case timing marks can be off slightly...

It's just the seat hole diameter that varies in size from 1.2mm 1.5mm 1.8mm 2.0mm 2.3mm and 2.5mm. If the Viton tip appears worn you can swap them two or more sizes but never a one size jump and have them work well.

I would not use the advance feature on your timing light because your rpm advance will be increased early due to the ignition coil firing at every 180-degrees. Ignition Timing Marks: In order to mark the coupler in the correct spot, you'll need to use a TDC dial indicator tool through the...

Just max it out and your pipe will be the rev limit.

Clean your turf with some bleach & water with a nylon bristle brush then hand rub it with some 60-grit sandpaper to get the rough textured surface back. Also a new pair of shoes with a improved tread pattern might help.

You should put this in the official McMaster Carr part number list so people can find it later. http://www.x-h2o.com/threads/31581-The-Official-McMaster-Carr-Part-Number-List

I would only replace the flywheel if the magnets have impact damaged and removing the gas tank makes it a bit easier.

The flywheel is a lightened stock 65U charging type but you'll need a 65U stator coil if you have a 1999 GP1200.