Search results

yeah sounds like a loose wire. No sparks will happen off a ground wire unless there is insufficient ground or a loose connection. I have never taken a starter apart. Is it possible that the starter is going bad causing an arc? Is this even a symptom of a starter on its way out. Normally mine...

Sick...... Raise the bar, 1 handed BF on Day 1 trials....

I would not go with what skat recommends 9/17. That seems to be a decent all around prop but not one that will work the best. After $225 you wont be getting a new prop so most deal with their recommendations. Get the sxr prop but do not cut it back just yet. Get your peak rpm readings and get...

Keep middle closed. Opening the bottom screw will give you more top end. Closing the bottom and opening the top will give you more bottom end snap. 1 screw must remain open at all times. That sucks about your knee. Only good thing is that its not May yet. Heal up.

Frosty, ski looks great. Water should be good in like July with our weather, lol

A wire wheel attachment on the drill helps alot. I think harbor freight has cheap ones. Just go nuts with it and use your shop vac to suck up the foam dust that it creates. Still PITA either way.

PS: just cut back the plug wire about 1/4" and push the boot back on. Use dielectric grease in the boot. Auto store NGK have a screw on top make sure that is tight.

19 years old: Many options - Time for spring tune up Keeping stock 38 - 7/8 turn out for high and low screw. Thats stock meaning stock everything: pipe and are filter I would ditch the 38 keihin and get a mikuni. Or pick up a set od sxr takeoffs. Make sure you pressure test the low end. Crank...

Korn explain the mod. I got to get my son more power on his.

If anyone is looking to sell a 145 set back Pm me. Fingers crossed. I have always heard 84 or 85 seems to work well on reduction for higher hp kawi motors/pumps.

maybe just lower them a bit

My thoughts as well.

No pole spring will hold the pole exactly where you want it throughout the range of motion of the pole. 2 bolts will squeeze down as much force as just using the oem. Just drill it out and replace the plastic washers with metal ones and your good. If you use the plastic washers it will never be...

Just remove the plastic washers and use metal ones. Also the one side of the bracket has threads that the bolt threads in. Drill that out and then tighten down that beach.

I use mine after the "T" within 3 inches of the stinger. Other side of "T" is going overboard to the pisser. I also have a mikuni primer fitting (water restrictor) between the FCV and the stinger. The idea is for the FCV to eliminate water going to the end source, mine being the stinger pipe and...

any videos of this hull in action?

Call eric malone. He sets most mid 800 cc motors up with the 145 kawi mag. If you are looking for a 148 I think the skiclinic has a couple maxxx5 yamha version pumps for sale. Decent price too. But if your set on a kawi then I would deffinitiely speak with eric.

148 kawi? You running a bigger motor than the 5mm u spoke of earlier. Probably to big imo.

Malone recommended the 145mm mag for the setup. He uses the 142mm mag with stock sxr: stock electrics, Factory pipe and some higher compression than stock to do backflips with the Q8. My goal is to get the Q8 next season or the season after. I am a bit hesitant on that large of a pump as well...

outer shaft tube has been sealed up flush with 5200. Season is about over up here is a few weeks so I can check the engine side of the tube and reseal the hull bearing plate as well. The pump tunnel on my ski might be to small or insufficient for the amount of water the motor needs. I am using a...