Search results

Why don't you offer some those nice, high quality, stainless steel ratchet tie down straps with the stainless snap hooks on the ends that Suncor makes? I'm sure I'm not the only one on the X that would like a pair

Another thing to consider when buying a pole, if you break it, will the manufacture stand behind it. In my experience, X-metal has been the best at standing behind their products in the industry. Poles take a beating, they do break, X-metal has replaced a couple for friends of mine with no...

You make it look so easy!

There is two sides to every story, and I know no one here wants to hear either. I have three friends besides me that bought Martix's (Boyer, Bill Adkins and Mark Gomez). You can ask any of us, Bobby was straight forward, honest and business like. The only problem I had and I expect it from any...

Yes, the wide rails made the SJ really stable and still corners very well, but would not handle a bouy course as well as the stock railed SJ. This is an excellent mod for the surf, especially in the white water. It is a mod that makes the ski so much easier to ride. It may not carve a bouy quite...

I would by the TBM because they stand behind their product. I had a problem with one of their flywheels, they replaced it without question.

check for a hair line crack at the bottom of the water jacket where it meets the transfer ports. it is the reason they made gridle heads

Contact Terry Cable, terrycable.com They will make you any cable at any length with any ends and in all stainless inner and outer. I have one ordered for my x-metal trim and the cost is $58.00

It's probably not a bent drive shaft, he probably did the same stupid move that I did when I first installed my Solas pump. When I removed the drive shaft out of the stock pump, the bearings were stuck on the shaft. Instead of removing the front bearing from the shaft and driving it into the new...

I like the shadows on the water coming in from the back flips, especially the one with the ski and no rider.

I have seen a needle-in-seat stick once and it made the motor act just as you describe, but more than likely your linkage between the carbs have slipped. Pull your flame arrestors and look down the carbs and make sure both butterflies are moving together. Do it while the motor is running as the...

Mine use to blow off all the time when I had the Epic ignition, I changed it out for a MSD Enhancer and have not had a boot blow off in over a year and I ride every weekend!

The pump is machined different than a stock one. The distance from where the front bearing seats and the face of the Solas pump (if I remember correctly) is about 5mm less, this moves the shaft forward. I had the this issue with my Solas, but I was lucky , I had a fairly large gap at my...

I put the MSD Enhancer back in and the motor has been rock solid reliable since. I lost a little bottom end compared to the Epic, but I am glad to give it up for reliability. If you want to keep the Epic, try replacing your rectifier, it's the only electrical componet that I didn't replace twice.

Boyer, my failures were caused by the Epic CDI backfiring, not fatigue. I had no wristpin bearing failures before or after I tossed the Epic. It's a shame that the Epic works great on some ski's and not the others. The concept is great. Warning: If the Epic causes your ski to kick back or...

Holy crap Josh, not only do you do excellent work, but you do it lighting fast!!!!! Great job

I had to add under 25mm padding to top of the footholds and under them. Needs some tweeking

Not a big beer drinker, just a warm up until I break out the blend! Nick, I guess I should try a good German beer.

The last of the mod pictures until I get motivated to rework the sponsons, maybe sometime this fall

More pictures