Search results

I think its 8mm 1.25 pitch. I even tapped the plastic in the nozzle too.

Hey, How is the 8.75 hp? I was thinking of using a 13 hp. What torque converter is that? How much did you pay for it? Also where did you get the spool halts? I'm thinking of building one out of stainless for the ocean.

photo

So I got my new 2011 superset. I've been on them a lot before but I was like.... woah "Not a lot of sliding going on here" I cut the ride plate flush with the rear of hull. I drilled and tapped third spot on steering plate. Also drilled hole in closer to nozzle. I tried it and I like it. I...

What is cost actually?

no.

I went to a local dealer, could not even find it. (4 stroke central) I went to sbt, and bought the wrench (15mm). Got home and it would not fit. Guess what, I tried a 17 again and it fit. ha ha So i loosened the other allen bolts, then tightened them all down evenly. I took it for a ride...

Its a 15 mm. I ground down a 15 open end wrench and it will would not fit. I do still have the carbs on, they are on so nice with new gaskets I do not want to take them off. I rode the ski around 3 miles from the boat launch to my floating dock. The ski ran great. Took the seat off and I could...

Hey, I just finished rebuilding an old seadoo rx. I'm looking to borrow a seadoo ex wrench. I could go buy one at sbt, but I figured I would just see if maybe someone local will let me borrow it for 20 minutes.

hmmm. Thanks for the replies. The fiberglassing will be done only on the inside. Its already water tight.

I just picked up a used fiberglass dock box. It has a small crack on the end by the hinge that needs to be fixed. Also I am hoping I can reinforce all areas of the dock box as well. They all are a little flimsy. I've done fiberglass repairs on boats and such before. Can anyone give me...

I'm building a seadoo 951 carb engine and am unsure on piston to cylinder wall clearance. Its bored 2mm over to 90. I had to go with wiseco pistons. The box says .004 But I keep hearing because they heat up faster and many people don't warm up watercraft enough that I need to set it at...

http://cozumelextreme.com/cozx_mx http://www.facebook.com/motoparkcozumel/info The owner Pat is cool, the track is awesome. I did not get a chance to ride it. I know there is a super jet over by "mikes beach place." I'm sure Pat can help you get on it if you want. I'd skip the stand up...

Change the seals.

+ 1 on new engine seals.

You need reg. I got a ticket in FL for driving a 49 cc scooter with out it.

Tired = Runs just fine however I have the strong desire to upgrade to bigger and better.

Let off on the throttle for half a second before initiating the slide, it will unhook the back of the ski. Also lean forward. 08+ slides just fine after you get enough hours logged riding them.

Its doable with the 07+ cable. I've seen it done on many skis. It involves relocating the cable end closer to the nozzle(to the middle of the ski). Then on the other end I forget exactly how its set up. I'm not sure if we had to use spacers at the bar stop to protect the cable from breaking...

Is the oil cooler really needed? You put that on for what application? What is the extra tube and hoses by the radiator?