Search results

Anyone have any experience with their motor mounts? Good enough for a couch (blaster2) or stick with OEM?

2.4 acres is plenty big enough for a small pond.

Even if it’s not exact if something gets stolen I’d still take it being in a target radius vs being clueless which way it went.

If you have Apple products already these things are a must. If I care enough about certain things it has one stashed somewhere on it.

Not bad for occasional use, but a little slow like most cheap cigarette ones for car tires. On the subject of inflators this thing is the bees knees for whatever inflatables you have. We have a couple that paid for themselves ($17 when I bought) for air mattresses when camping and rafts for the...

So you weigh 145lbs and criticize anyone that may have have trouble rec’ing a flat water hull. Weird flex.

Ok. Looking at H2Os site it seems there are only options for AM skis. Guy I’m wanting to refer has a SJ with shortened pole and wider riser bars and OEM and another make covers aren’t fitting. Any other suggestions?

I remember awhile back someone was making covers that fit I believe SJs with pole and bar mods and some of the AM skis. Can’t find the thread or who it was now and wanting to refer someone to them if they’re still making them. If anyone can help me find this I’d appreciate it.

From everything I’ve read that’s not true. Only you can see where the tracker is unless you set to discoverable so a finder can gain contact information for you.

Not sure how many have seen this but looks like a great answer to keeping your ski from “walking” off. Basically a Tile type tracker that’s been discussed before but it’s supported by the billion or so Apple products vs 3-4 million Tile products so coverage is actually a thing. Anyone ever...

Waterski gloves FTW.

Bump

1998 Yamaha Superjet Sold; Located in Wilmington, DE 19808 Stock 701 with Riva RPM package includes: Riva head with domes (high test pump gas) Riva Freeride (Factory Type 4?) exhaust Riva Groovy rideplate Worx 205 scoop intake grate MSD enhancer Waterdawg REV footholds, HydroTurf JetWorks CSS...

Get an old couch hull and split the halves. Use the bottom as a sleigh for you standup. Put some padding and tie downs and rig a short, fixed tow bar for the boat.

How much room inside do you have? Could you use a countersunk washer and bolt like rickter footholds use?

I doubt carbs themselves need replacing. Search on Greenhulk.net for 65u 1200 carb mods by ‘OsideBill’ (RIP). He was a guru on these engines and has proven specs over OEM settings. You’ll find you want to ditch the choke and run a primer and run double check valves on the fuel metering...

Remove a hair of material from the rings where they pinch with sandpaper. I used a 3” roloc sanding disc on like a 2” mandrel and worked perfectly. Had same problem.

Personally I wouldn't build a pump with a press again. The freezer/oven method is just too easy especially for at-home builds.

I don’t think I’d trust these things that aren’t meant to be in the water to begin with. I’m just imagining a failed roll or something you’re going to have a 100ft web of death floating around your ski.

That’s what you need but good luck finding a new pontoon with large front deck these days. Seems like they don’t manufacture them like that anymore for liability reasons. I’ve always thought the best setup would be a bunk setup that would be angled up over the outer rear pontoons (for 2 skis)...