Search results

That is how they fit in the edge because of the angle of the rear of the hull. I filled the void with epoxy. Silicone or 5200 would work fine as well. It's just a cosmetic issue, it doesn't effect the function of the ball Sent from my iPhone using Tapatalk

This should be the standard in scupper design instead of the flap. I have no reason for a bilge pump now. Only reason I have a bilge pump in the ski now is incase of an emergency like water line or hood coming off Sent from my iPhone using Tapatalk

The bell shaped piece is a very tight fit into the the scupper tube. It's not going anywhere, especially once you epoxy the plate on the back. I did not use the set screws. Sent from my iPhone using Tapatalk

I know a alot of people have had good luck with them in fresh water flaterwater applications. Mine lasted fine when riding flatwater/boat chasing. Never had one go bad until I used them in the surf. The two that died using total loss died after less than half a tank of fuel. The one on charging...

I had three of the advance auto lithium batteries go bad for no apparent reason. Two were with total loss, one was with a charging system.

I noticed little to no added vibration when going from OEM sj mounts to OEM couch mounts.

Since we do not have to make camp site reservations does that mean campsites are on a first come first serve basis or is camping allowed anywhere on the beach? Sent from my iPhone using Tapatalk

Great looking build! I also just installed my RRP trim, took me a little while to figure it out. Some directions would have been great but I managed to figure it out by looking at pictures like you. Mine came with two different length cable holders. I'm assuming that one is for a 155 and one for...

We plan on being there sometime Thursday afternoon

Four layers of 25mm padding glued together, shaped, then wrapped in a final layer of 9mm padding. Glued to the firewall and then added a layer of turf. Extremely comfortable and effective. Sent from my iPhone using Tapatalk

I'll gladly come give it a spin! Interested to see how that pipe works on a 701. I'll be there with jrock, I'm sure we will cross paths at some point on the beach.

7/12 sounds like a better starting point. 9/15 is 144mm pump territory with a stock 701

This about about a lithium is good for

I went through two Battery tender batteries and three autocraft lithium batteries before I officially gave up on lithium batteries. They seemed to last fine for flat water riding with total loss or a charging system if properly maintained. Every time I put one in the surf it would self destruct.

Even the slightest amount of water ingestion will kill plugs rather quickly, especially in salt water.

Added the thrust EZ drain to my edge today. Ran into the same fitment issues as mentioned before. Because of the angle of the hull you end up with a gap between the ball drain and the plate that glues to the hull. The gap doesn't alter the effectiveness of the drain in anyway though. I filled...

People have had good luck with all the klotz oil that you mentioned I personally run the ski craft

The only thing holding the scupper flap on are a coupler similar bolts. I just ordered one from thrust to replace my leaky scupper.

Do you need to run the coupler spacers to clear the rear tank?